Abstract:Municipal solid waste (MSW) is one of the top contributors in greenhouse gas (i.e. methane) emissions - particularly from landfill disposals. However, it could be a remarkable source of renewable energy. In Bangladesh, generation of municipal solid waste is at least 2.7 million tonne per year in the major cities, implying a heavy environmental burden. On the other hand, there are several coal-based power plants are in the pipeline to meet the increasing energy demand in Bangladesh with the potential of significant CO2 emission. To find a remedy to the above situation, a power plant using Integrated Gasification and Combustion Cycle (IGCC) technology with pre-combustion carbon capture is considered in this study. IGCC has the advantage of producing high quality syngas from a wide variety of feed and assists in the capture of CO2 at a lower cost while providing high electric efficiency. The power plant was simulated by commercial simulation packages (Aspen PLUSTM and Aspen HYSYSTM) using MSW and bituminous coal (Indonesian) as a combined feed. With a feed rate of 1800 tonne per day, Syngas produced from an entrained flow type gasifier was then treated for CO2 removal using mono-ethanol amine (MEA) solvent after necessary shift in a high temperature shift reactor. About 91% efficiency was achieved in the shift reactor while the CO2 capture efficiency was varied for this study from 30% to 85%. Further parametric variation was studied by varying the moisture content of MSW and MSW to coal feed ratio. Through combustion of the H2 rich syngas in a gas turbine and subsequent steam cycle with reheat resulted in 125 MW of electricity at an efficiency of 28.95% while capturing 50% of the CO2 generated in the process for an MSW to Coal feed ratio of 1:1. With variation in moisture content especially during monsoon season, the plant efficiency could be affected remarkably. On the other hand, it was observed that the energy requirement varied from 6 to 8 MW for every 10% increase in CO2 capture quantity. Overall, by capturing 50% of the generated CO2, it is possible to reduce the emission of a same size ultra-supercritical coal-based power plant from about 700 kg CO2/MWh to about 360 kg of net CO2/MWh incorporating co-feeding and pre-combustion capture in an IGCC power plant. Chemical Engineering Research Bulletin 21(2020) 37-42

Performance analysis of refuse‐derived fuel gasification plant with carbon capture and storage for power, heating, and hydrogen production

Plasma gasification of refuse derived fuel in a single-stage system using different gasifying agents

Techno-Economic Efficiency Estimation of Promising Integrated Oxyfuel Gasification Combined-Cycle Power Plants with Carbon Capture

Process simulation development of a clean waste-to-energy conversion power plant: Thermodynamic and environmental assessment

A Hybrid Energy System Based on Externally Fired Micro Gas Turbines, Waste Heat Recovery and Gasification Systems: An Energetic and Exergetic Performance Analysis

Pyrolysis and Gasification of a Real Refuse-Derived Fuel (RDF): The Potential Use of the Products under a Circular Economy Vision

Performance analysis of RDF gasification in a two stage fluidized bed-plasma process

Comparative study of steam, organic Rankine cycle and supercritical CO2 power plants integrated with residual municipal solid waste gasification for district heating and cooling

Study of the Combustion Process for Two Refuse-Derived Fuel (RDF) Streams Using Statistical Methods and Heat Recovery Simulation

Analysis of the Efficiency of Landfill Gas Treatment for Power Generation in a Cogeneration System in Terms of the European Green Deal

Simulation and multi-aspect analysis of a novel waste heat recovery process for a power plant producing electricity, heating, desalinated water, liquefied carbon dioxide, and natural gas

Analysis of biomass and waste gasification lean syngases combustion for power generation using spark ignition engines

A Polygeneration Process for Heat, Power and DME Production by Integrating Gasification with CHP Plant : Modelling and Simulation Study

Thermodynamic analysis of a sorption-enhanced gasification process of municipal solid waste, integrated with concentrated solar power and thermal energy storage systems for co-generation of power and hydrogen

Analysis of a novel power plant based on tars from biomass gasifier as fuel gas

Environmental and energetic analysis of coupling a biogas combined cycle power plant with carbon capture, organic Rankine cycles and CO2 utilization processes

Parametric Study on Co-Feeding of Municipal Solid Waste and Coal in an IGCC Power Plant with Pre-Combustion Carbon Capture

Enhanced coal gasification heated by unmixed combustion integrated with an hybrid system of SOFC/GT

Simulation Analysis of the System Integrating Oxy-Fuel Combustion and Char Gasification

Simulation of a sorption-enhanced water gas-shift pilot technology for pure hydrogen production from a waste gasification plant

Co-gasification of rural solid waste and biomass in rural areas: Simulation and plant-scale process