Of flow past finite blunt plates using proper orthogonal decomposition
Liu Liu Shi,Ying Zheng Liu
2009-01-01
Abstract:In this study, PIV measurements of flow past finite blunt plates with length-to-thickness ratio / L D = 3, 6, and 9 were performed in a low speed water channel. The Reynolds number was 1000 D Re = based on the plate’s thickness, D. Detailed examination of the flow past finite blunt plates with different length-to-thickness ratios displayed different flow characteristics. The large scale structures were found to make great contribution to the unsteadiness of the flow. Proper orthogonal decomposition (POD) analysis using 500 realizations of PIV velocity fields were performed to indentify the dominant flow structures. INTRODUCTION The finite blunt plate is a common configuration found in many structures, such as bridge decks, high-rise buildings, heat sinks in electronic equipments. Despite of its simple geometry, the flow past finite blunt plates has received increasing attention since it is associated with a lot of engineering problems like flow-induced vibration, flowstructure interactions, intensified heat and fluid transfer. The flow separates from the leading edge and not always reattaches on the plate’s surface, depending on the plate length-to-thickness ratio / L D , L is the length of the plate and D is the plate’s thickness. The flow patterns will be totally different for plates of different ratios. Numerous efforts have been made, both experimentally and numerically, to study the characteristics of the separated and reattaching flow over finite blunt plates (Parker and Welsh, 1983; Nakamura et al., 1991; Ohya et al., 1992; Hourigan et al., 2001; Mills et al., 2003). However, no detailed description of the global features of this type of flow has been reported. In the present study, PIV measurements were carried out in a low-speed water channel at a Reynolds number 1000 D Re = to study the flow characteristics in more detail. A high-resolution CCD Camera (RedLake, USA) with 11 Mega pixels was used in experiments, enabling a detailed view of the wake at the spatial resolution of the vectors 0.47 mm × 0.47 mm. Three cases, e.g., / L D = 3, 6, 9, were adopted so that each case corresponds to a different shedding mode (Nakamura et al., 1991; Ohya et al., 1992) showing different features. Furthermore, Proper Orthogonal Decomposition (POD) analysis was performed on 500 PIV realizations to shed more light on the flow structures which modulate the global features. EXPERIMENTAL APPARATUS Experiments were performed in a recirculation open water channel shown in Fig. 1(a); the flow was circulated by a magnetic drive centrifugal pump (Iwaki, Japan) in a view to avoid structure vibration of the facility. A settling chamber, a honeycomb, 6 screens and a contraction were placed in sequence to ensure flow homogeneity. Dimensions of the test section were 150 mm (width) × 200 mm (height) × 1050 mm (length). The free-stream velocity was kept at 0.125 m/s, resulting in a Reynolds number Sixth International Symposium on Turbulence and Shear Flow Phenomena Seoul, Korea, 22-24 June 2009