Abstract:Magnetic fluid seals are widely used. However, during the filling process of the magnetic fluid, a large part of the magnetic fluid is attracted to the magnet, causing the loss of the magnetic fluid, and the magnetic fluid sealing device can easily cause damage to the pole teeth due to the problem of disassembly and installation. To solve the above problems, this article designs a pole piece integrated magnetic-fluid sealing structure and a new type of disassembly and installation method. The finite element method is used to calculate the magnetic field distribution of the pole piece integrated magnetic fluid seal structure, and the theoretical withstand pressure value is obtained according to the withstand pressure calculation formula. Three kinds of magnetic fluids were used to conduct comparative experiments on the magnetic fluid sealing device at different temperatures and different filling amounts. The results showed that the pressure resistance of the magnetic fluid sealing increased with the increase of the filling amount, and the increase of the saturation magnetization, consistent with theory. It is also found that the thickness of the pole piece is very thin. During the processing, Compared with the ordinary pole piece, the integrated pole piece has the advantage of large length, the coaxial is easily ensured, and the processing difficulty is reduced; second, during the filling process, all the magnetic fluid is sucked to the pole teeth, there is no loss of the magnetic fluid, and the pole teeth are intact after more than a hundred times of disassembly and installation, which further improves the life of the magnetic fluid sealing device.

Theoretical analyses and experimental study on the factors influencing the pressure resistance of the magnetorheological grease seal with pinch mode pole piece

Theoretical Analyses and Experimental Research on Micro-Nano Composite Magnetorheological Grease for Sealing Liquids with Different Viscosities

Numerical Simulation and Experimental Study on Magnetorheological Fluid Seals with Flexible Pole Pieces

Experimental Investigation on Unbalance Response of a Shear-type Magnetorheologic Grease Damper Flexible Rotor System

Pressure Capability Analysis of Magnetic Powder Seals and Pole Tooth Design by Multiparameter Optimization

DYNAMIC BEHAVIOUR OF SHEAR-TYPE MAGNETORHEOLOGIC GREASE DAMPER ROTOR SYSTEM

Theoretical Analysis and Experimental Study on the Influence of Magnet Structure on Sealing Capacity of Magnetic Fluid Seal

Numerical Analysis and Experimental Study on Pole Piece Integrated Magnetic Fluid Seal

Research on Mechanical + Magnetic Fluid Composite Dynamic Sealing Technology of Stirring Shaft of Pressured Reaction Axe

Theoretical Analysis and Experimental Study on Loading Process among Stages of Magnetic Fluid Seal

Experimental Research on Static and Dynamic Magnetic Powder Sealing Used by Micro-Nano Composite Magnetic Particles

Numerical and Experimental Study of Magnetic Fluid Seal with Large Sealing Gap and Multiple Magnetic Sources

Characteristic analysis and squeezing force mathematical model for magnetorheological fluid in squeeze mode

Experimental study of surface roughness on improving the tribological performance of sealing pairs in magnetorheological damper

Study on the Effect of Magnetorheological Fluids (mrfs) on the Sealing Performance

Design and experiment study of a novel dual-channel independent-coil magnetorheological grease damper

Magnetic field simulation and experimental investigation of magnetic fluid seal based on rotating shaft

Studies of Magnetic Fluid Plane Sealing in Split Sealing Device

Experimental Study on the Hydrodynamic Lubrication Characteristics of Magnetofluid Film in a Spiral Groove Mechanical Seal

Experimental Study and Simulation on the Seal Pressure of a Ferrofluid Seal Using Radial-Charged Magnets

Experimental Research on the Seal of Non-Newtonian Magnetic Grease with High Viscosity