Abstract:Five tectonic modes of mantle convection are obtained and analyzed with three-dimensional numerical models in a spherical shell domain. The five tectonic convective modes are non-plate mobile-lid, plate-like mobile-lid, episodic plate-like mobile-lid, episodic stagnant-lid, and stagnant-lid convective modes, respectively. The typical characteristics of these five tectonic modes and their numerical classification criteria based on plateness, mobility, and their standard deviations are presented and discussed. The results show that the yield stress of the lithosphere has profound effects on the tectonic convective modes. With the gradual increase of yield stress, the tectonic mode of mantle convection changes from one to another sequentially through the aforementioned five modes. Additionally, as the Rayleigh number increases, the range of yield stress for the platelike mobile-lid convective mode decreases, and the dimensionless transition stress between different tectonic modes increases. Specifically, the dimensional transition stress between the non-plate mobile-lid convective mode and plate-like mobile-lid convective mode increases with the increase of Rayleigh number, but decreases between other tectonic modes. Furthermore, we find that the transition stress between different tectonic modes is inversely proportional to the internal heating rate, with the transition stress decreasing as the internal heating rate increases. The fitting analysis of the transition stress between tectonic modes shows that Earth’s current plate tectonics correspond to a lithospheric yield stress of 150–250 MPa, which aligns with the strength of serpentinized mantle rock determined by experimental petrography. If the Archean mantle was 300°C warmer than it is today, then the Earth was in an episodic stagnant-lid convective mode. The tectonic evolution of the Earth’s surface is closely related to the lithospheric strength and the process of thermal evolution. If the lithospheric strength was only 150 MPa, plate tectonics in the early mantle rapid cooling model would have begun before 3.8 Ga, and plate tectonics in the late mantle rapid cooling model would have begun at approximately 1.5 Ga. However, at a lithospheric strength of 200 MPa, plate tectonics in the late mantle rapid cooling model would have begun later than 0.95 Ga, and plate tectonics in the early mantle rapid cooling model would have begun at approximately 2 Ga. The early Earth was in the episodic stagnant-lid convective mode, which means that subduction might still have occurred at that time. The presence of the episodic plate-like mobile-lid convective mode in Earth’s later history indicates that there might also have been intermittent surface stagnation during plate tectonics, which may provide an explanation for the quiet period of tectonic activity at approximately 1.0 Ga on Earth. This indicates that tectonic inactivity during a geological period is not an indicator that plate tectonics did not begin.

Intraplate continental basalts over the past billion years track cooling of the mantle and the onset of modern plate tectonics

Plate tectonics through Earth's history: constraints from the thermal evolution of Earth's upper mantle

Global mantle perturbations following the onset of modern plate tectonics

Continuous Plate Subduction Marked by the Rise of Alkali Magmatism 2.1 Billion Years Ago

Enhanced deep carbon cycle marked by the upsurge of silica-undersaturated nephelinitic magmatism at the Proterozoic-Phanerozoic boundary

Correlating mantle cooling with tectonic transitions on early Earth

Modern-style arc magmatism since ca. 2.2 billion years ago revealed by Nb/Ta-Dy/Yb systematics in igneous rocks

Extrapolations of secular trends in magmatic intensity and mantle cooling: Implications for future evolution of plate tectonics

Continental crust formation on early Earth controlled by intrusive magmatism

Initiation of Plate Tectonics from Post-Magma Ocean Thermo-Chemical Convection

Modern-style continental tectonics since the early Archean

Tectonic Modes of Mantle Convection and Their Implications for Earth’s Tectonic Evolution Based on Three-Dimensional Numerical Simulations

Secular Change and the Onset of Plate Tectonics on Earth

Geochemical evidence for a widespread mantle re-enrichment 3.2 billion years ago: implications for global-scale plate tectonics

Early Neoarchean alternation of plate subduction and deep mantle upwelling

Rapid Mantle Convection Drove Massive Crustal Thickening in the Late Archean

Lithospheric thickness records tectonic evolution by controlling metamorphic conditions

Remnants of Earth's Oldest Continental Crust Formed by Subduction

Coupled Evolution of Plate Tectonics and Basal Mantle Structure

Thermal state and evolving geodynamic regimes of the Meso- to Neoarchean North China Craton

Mantle cooling and cratonization of Archean lithosphere by continuous plate subduction: Constraints from TTGs, sanukitoids, and high-K granites, eastern North China Craton