Abstract:Chemical dyes used in the textile industries are one of the major pollutants in water. Methylene blue (MB) is a commonly seen dye that creates hazardous health problems. In this article the photocatalytic degradation of MB by the nanocatalyst MoS 2 (Nano-MoS 2 ) and carbon dot (C Dots) incorporated MoS 2 (Nano-CD-MoS 2 ) is reported. The photocatalytic degradation of MB is analyzed based on the electron-hole recombination rate of the catalyst. Photoluminescence emission exhibited by the catalyst is used as a key indicator to probe the electron-hole recombination rate. Nano-MoS 2 was synthesized hydrothermally at 180 0 C for 8 h from ammonium tetra thiomolybdate (ATTM). C Dot was prepared following a green root from ash guard extract which later mixed with Nano-MoS 2 and kept in an autoclave at a temperature 140 °C for 4 h to get Nano-CD-MoS 2 . The photoluminescence (PL) and photocatalytic behavior of Nano-MoS 2 and Nano-CD-MoS 2 and their application for water splitting and water purification are reported. The incorporation of graphene and artificial C Dot into MoS 2 nanostructures are reported to increase the conductivity and active edge sites of MoS 2 that enhances the photocatalytic action. Since green C Dots are eco-friendly and easily synthesizable than artificial C Dots, as a novel study, this article investigated the influence of green C Dots on the PL and photocatalytic performance of nanosized MoS 2 . Nano-MoS 2 and Nano-CD-MoS 2 exhibited both upconversion and downconversion PL; accordingly the nanostructures were termed as amphi -luminescent. The amphi -luminescence property widens the photon absorption range and hence enhances the catalytic degradation of dyes. Nano-MoS 2 which exhibited lesser intensity of amphi -luminescence emission compared to Nano-CD-MoS 2 showed better results in degradation of MB. C Dots may bind with the valence band electrons of MoS 2 , resulting in the reduction of dangling bonds Dangling bonds can trap photo-induced excitons to hinder the rate of electron-hole recombination. So, fast electron-hole recombination occurs in Nano-CD-MoS 2 than Nano-MoS 2 . Fast electron-hole recombination supports radiative electron-hole recombination while suppresses the non-radiative energy transfer of electrons and causes high PL intensity. However, according to the energy level diagram, Nano-MoS 2 with minimal electron-hole recombination rate is more favorable for O 2 /O 2 – ,OH/ OH – andOH/H 2 O reactions that facilitate MB degradation. Photocatalytic activity of catalysts were confirmed by measuring the photocurrent from a simple custom-made two-electrode water photolysis cell where the nanocatalysts were dispersed in electrolyte. Lead and steel rods were used as electrodes. Multimeter was used to measure current. Nano-MoS 2 exhibited better performance with a maximum photocurrent of 141 μA. Influence of green C Dots in energy levels, PL and photocatalysis of MoS 2 and mechanisms of PL and degradation of MB are thoroughly investigated in this article.

Highly Effective Photocatalytic Degradation of Malachite Green Dye for Waste Water Treatment through 1T/2H MoS2 Nanoflower

Enhanced dye degradation using 2H-MoS2 and 1T@2H-MoS2: A comparative study

Amphi-Luminescent MoS 2 nanostructure for photocatalytic splitting of water and removal of Methylene Blue

Application of 2D MoS2 Nanoflower for the Removal of Emerging Pollutants from Water

MoS2@MIL-101(Fe) functionalized carboxylated loofah as a platform for the photodegradation of tetracycline and methylene blue from wastewater

MoS2-Cu/CuO@graphene Heterogeneous Photocatalysis for Enhanced Photocatalytic Degradation of MB from Water

Enhanced Photocatalytic Degradation of Cr (VI) and Organic Pollutants Using Novel 3D/2D MoS 2 /SnS 2 Heterostructures for Water Remediation

Enhancement of visible light driven dye degradation and photocatalytic H<sub>2</sub> evolution over MoS<sub>2</sub> through combination with perylene diimide aggregates

Synergistic exploration of dye degradation and pulse photoresponse using MoS 2 nanosheets: Towards sustainable remediation and optoelectronic advancements

Preparation and Photocatalytic Performance of MoS 2 /ZnS/ZnO‐T Heterojunction Photocatalyst for Dye Degradation in Water

Recent advances and perspectives of molybdenum disulfide and molybdenum disulfide based nanocomposites for adsorption and photocatalytic degradation of organic dyes: a review

Hierarchically design MoS2/CdNi@RGO ultra-thin hybrid sheet for Photocatalytic degradation of organic contaminants fingerprinting in environmental matrices

MoS2 and MoS2 Nanocomposites for Adsorption and Photodegradation of Water Pollutants: A Review

Fabrication of MoS 2 restrained magnetic chitosan polysaccharide composite for the photocatalytic degradation of organic dyes

Recent advances and perspectives of MoS2-based materials for photocatalytic dyes degradation: A review

MoS2 nanoflowers functionalized with C3N4 nanosheets for enhanced photodecomposition

Photocatalytic Performance of ZnO@ZnS Core–Shell Heterostructures for Malachite Green and Rhodamine B Dye Degradation

TARGETING PHARMACEUTICAL PHENOL; A THOROUGH ANALYSIS OF MANGANESE DOPED MOLYBDENUM DISULFIDE (MoS 2 ) CATALYST, AUGMENT BY MB DYE ASSESMENT

Mechanical milling: a sustainable route to induce structural transformations in MoS2 for applications in the treatment of contaminated water

Hierarchical TiO2 nanostructures sensitized with MoS2 nanosheets: An efficient and reusable heterojunction photocatalyst for sunlight-assisted degradation of organic dye pollutants

MoO2 nanostructures synthesized via hydrothermal method for enhanced Methylene blue decontamination