Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Convective heat transfer with condensation in crossflow of a circular cylinder: Experiments and simulations

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Experimental Study on Film Condensation Characteristics at Liquid Nitrogen Temperatures

Numerical Simulation of Condensation for R410a in Horizontal Round and Flattened Minichannels

Numerical Simulation of R410A Condensation in Horizontal Microfin Tubes

Numerical Investigation of Convective Condensation with the Presence of Non-Condensable Gases in A Vertical Tube

Analysis of enhanced heat transfer of film condensation on vertical fluted tubes

Condensation in Horizontal Smooth Tubes: A New Heat Transfer Model for Heat Exchanger Design

Flow and heat transfer characteristics of ambient air condensation on a horizontal cryogenic tube

Experimental Study Of Condensation Flow Inside Horizontal Smooth, Herringbone And Three Enhanced Surface Tubes

Experimental Study on Heat Transfer Characteristics of A Condenser in the Presence of Air

Heat transfer characteristics in vertical tube condensers: Experimental investigation and numerical validation

Numerical Simulation of Flow Patterns and the Effect on Heat Flux During R32 Condensation in Microtube

Experiments of Condensation Heat Transfer in Micro Channel Heat Exchanger

Heat Transfer Characteristics of Hydrocarbon Mixtures Refrigerant During Condensation in a Helical Tube

Theoretical Analysis and Experimental Investigation on Local Heat Transfer Characteristics of HFC-134a Forced-Convection Condensation Inside Smooth Horizontal Tubes

Convective Condensation Inside Horizontal Smooth and Microfin Tubes

Simulation of Condensation Flow in A Rectangular Microchannel

Influence of heat flux on forced convective heat transfer in duct with micro-cylinder-group

Interfacial Wave Behavior and Its Effect on the Flow and Condensation Heat Transfer in a Microtube