Abstract:Optimization methods have been widely applied to the aerodynamic design of gas turbine blades. While applying optimization to high-fidelity computational fluid dynamics (CFD) simulations has proven capable of improving engineering design performance, a challenge has been overcoming the prolonged run-time due to the computationally expensive CFD runs. Reduced-order models and, more recently, machine learning methods have been increasingly used in gas turbine studies to predict performance metrics and operational characteristics, model turbulence, and optimize designs. The application of machine learning methods allows for utilizing existing knowledge and datasets from different sources, such as previous experiments, CFD, low-fidelity simulations, 1D or system-level studies. The present study investigates inserting a machine learning model that utilizes such data into a high-fidelity CFD driven optimization process, and hence effectively reduces the number of required evaluations of the CFD model. Artificial Neural Network (ANN) models were trained on data from over three thousand two-dimensional (2D) CFD analyses of turbine blade cross-sections. The trained ANN models were then used as surrogates in a nested optimization process alongside a full three-dimensional Navier–Stokes CFD simulation. The much lower evaluation cost of the ANN model allows for tens of thousands of design evaluations to guide the search of the best blade profiles to be used in the more expensive, high-fidelity CFD runs, improving the progress of the optimization while reducing the required computation time. It is estimated that the current workflow achieves a five-fold reduction in computational time in comparison to an optimization process that is based on three-dimensional (3D) CFD simulations alone. The methodology is demonstrated on the NASA/General Electric Energy Efficient Engine (E3) high pressure turbine blade and found Pareto front designs with improved blade efficiency and power over the baseline. Quantitative analysis of the optimization data reveals that some design parameters in the present study are more influential than others, such as the lean angle and tip scaling factor. Examining the optimized designs also provides insight into the physics, showing that the optimized designs have a lower amount of pressure drop near the trailing edge, but have an earlier onset of pressure drop on the suction side surface when compared to the baseline design, contributing to the observed improvements in efficiency and power.

Physics-Informed Neural Network surrogate model for bypassing Blade Element Momentum theory in wind turbine aerodynamic load estimation

PINN Based Data Driven Magnetics Loss Modeling

Novel Machine-Learning-Based Stall Delay Correction Model for Improving Blade Element Momentum Analysis in Wind Turbine Performance Prediction

Estimation of rotor and main bearing loads using artificial neural networks

RANS-AD based ANN surrogate model for wind turbine wake deficits

On the Application of Machine Learning in Savonius Wind Turbine Technology: An Estimation of Turbine Performance Using Artificial Neural Network and Genetic Expression Programming

A Surrogate Model for a CAES Radial Inflow Turbine with Test Data-Based MLP Neural Network Algorithm

Surrogate Modeling and Aeroelastic Analysis of a Wind Turbine with Down-Regulation, Power Boosting, and IBC Capabilities

Optimization of Turbine Blade Aerodynamic Designs Using CFD and Neural Network Models

Wind turbine power coefficient models based on neural networks and polynomial fitting

Comparison of aerodynamic models for horizontal axis wind turbine blades accounting for curved tip shapes

Dynamic wake field reconstruction of wind turbine through Physics-Informed Neural Network and Sparse LiDAR data

A Physics-informed Neural Network for Wind Turbine Main Bearing Fatigue

A neural network surrogate model for the performance assessment of a vertical structure subjected to non-stationary, tornadic wind loads

RANS-PINN based Simulation Surrogates for Predicting Turbulent Flows

T2FL: An Efficient Model for Wind Turbine Fatigue Damage Prediction for the Two-Turbine Case

Wind Turbine Performance in Controlled Conditions: BEM Modeling and Comparison with Experimental Results

Surrogate models for predicting stall-induced vibrations on wind turbine blades

Modelling of aero-mechanical response of wind turbine blade with damages by computational fluid dynamics, finite element analysis and Bayesian network

Artificial Neural Networks based wake model for power prediction of wind farm

Uncertainty Quantification Analysis in the Blade Element Momentum Method