Abstract:Introduction: Meteorites provide a “window” into planetary interiors; allowing us to better understand evolution of the early solar system and planetary differentiation. Iron meteorites in particular present a unique opportunity to study core formation processes. The variety in chemical compositions between iron meteorite groups points to complex accretion and differentiation histories of their parent bodies. Understanding coremantle segregation processes under different accretionary conditions can provide insight into the range of chemical compositions recorded in meteorites. Two mechanisms are often cited to describe metal segregation and core formation: (1) the existence of a magma ocean and (2) metallic melt percolation through a solid silicate matrix [1]. Planets may experience different segregation processes depending on heat source and thermal evolution, but differentiation via percolation is likely the dominant process for smaller planetary bodies when heated to temperatures high enough to melt the metallic component [2]. Metallic melt migration through a porous matrix is primarily controlled by melt volume and the chemical composition [3–5]; the latter most notably affects the wettability of the liquid. Iron meteorites, dominantly composed of Fe and Ni, also contain small amounts of light elements including sulfur, silicon, carbon, and phosphorous [6]. Light elements have proven to reduce melt/olivine interfacial energy, though show a range in this effect. For example the addition of sulfur or oxygen reduces the dihedral angle while silicon has no effect [1,7–11]. However, studies to date have largely determined percolation behavior for binary or ternary systems via dihedral angle measurements. Our objective is to better understand the physical process of percolation in a complex system of multiple light elements. Our experiments address the following questions: (1) What are the compositions of the immiscible liquids in the Fe-Ni-Si-S-C system? (2) What is the percolation behavior of the immiscible liquids (i.e., can the two phases physically separate during transport through cracks/grain boundaries)? (3) How does temperature affect percolation behavior, especially when partial melting of metal occurs? (4) Can we relate composition evolution during percolation to meteorite compositions? Methods: To simulate liquid metal percolation in a small planetary interior, we performed piston-cylinder experiments at temperatures between 1100–1600 °C at 1 GPa. Two compositions were employed to observe the effects of light elements on percolation behavior: Fe + 5 wt.% Ni + 6 wt.% Si + 2 wt.% S and Fe + 5 wt.% Ni + 2 wt.% Si + 6 wt.% S. Powders were loaded into graphite capsules to allow C saturation in the experiments (£ 6.4 wt.%). Within the graphite capsule, we used two capsule configurations: (1) San Carlos (SC) olivine inner “capsule”, where powdered SC olivine fully surrounded the metal sample or (2) a SC olivinemetal-SC olivine “sandwich”. The capsule along with MgO spacers was placed within a half inch talc-pyrex assembly with graphite heaters. Samples were pressurized to 1 GPa and heated to 800 °C and sintered for two hours. The experiments were then heated to the target temperatures and held for 3–12 hours before quenching. The experimental products were polished and their chemical compositions analyzed with the electron microprobe (EMP). Apparent dihedral angles were measured on 2D images captured during EMP analysis or with the scanning electron microscope (SEM). Results: Both starting compositions form immiscible Fe-Ni-S and Fe-Ni-C liquids (Fig. 1) that coexist with a solid Fe-Ni-Si-C alloy at lower experimental temperatures. The Fe-Ni-S melt wets the surrounding olivine grains and carries the non-wetting, C-rich Fe-Ni alloy into the olivine matrix. The C-rich melt is always found suspended within the Fe-Ni-S melt and shows no evidence of segregation from the wetting phase (Fig. 2).

Relief Forms on the Surface of Cosmic Spherules as Evidence for Their Origin

Ferrovolcanism on metal worlds and the origin of pallasites

Behavior of Sulfur by the Example of Iron Balls from Regolith Samples from Luna-24 (Mare Crisium)

Extraterrestrial sedimentary rocks on Earth

Challenges of identifying putative planetary-origin meteorites composed of non-igneous material

Chemical Classification of Spherules Recovered From The Pacific Ocean Site of The CNEOS 2014-01-08 (IM1) Bolide

PERCOLATION BEHAVIOR IN THE Fe-Ni-Si-S-C SYSTEM AND INFLUENCE ON METEORITE COMPOSITIONS

Possible records of space weathering on Vesta: Case study in a brecciated eucrite Northwest Africa 1109

Chemical compositions of Fe‐rich relict olivines from cosmic spherules, understanding their links with ordinary and carbonaceous chondrites

Evidence for the extraterrestrial origin of a natural quasicrystal

Contribution of biomineralization during growth of polymetallic nodules and ferromanganese crusts from the Pacific Ocean

Trace elemental behavior in the solar nebula: Synchrotron X-ray fluorescence analyses of CM and CR chondritic iron sulfides and associated metal

An Example of High-T, High-Symmetry Crystallization: Spherical (Mg,fe)-Oxides Formed by Particle Attachment in the Shocked Martian Meteorite Northwest Africa 7755

Discovery of Spherules of Likely Extrasolar Composition in the Pacific Ocean Site of the CNEOS 2014-01-08 (IM1) Bolide

Textural Study of Vesicles in Tagish Lake (C2-ung) Meteorite Fusion Crust: Constraints on Vesicle Formation during Their Entry into the Earth's Atmosphere

The Puzzle of Meteoritic Minerals Heideite and Brezinaite; Are they Iron-based Superconductors? Are they Technosignatures?

Be,La,U-rich spherules as microtektites of terrestrial laterites: What goes up must come down

Chondrule Precursors and Cooling Paths: the Sulfur Evidence

Evidence for Biogenic Processes During Formation of Ferromanganese Crusts from the Pacific Ocean: Implications of Biologically Induced Mineralization

Space Weathering On Airless Planetary Bodies: Clues From The Lunar Mineral Hapkeite

Phase, morphology, elemental composition, and formation mechanisms of biogenic and abiogenic Fe-Cu-sulfide nanoparticles: A comparative study on their occurrences under anoxic conditions