Abstract:Reuse of brines in the chlor-alkali industry can be benefitial both in terms of new material source for the industry and environmental impact reduction of the brines disposal. In this thesis, reuse of Seawater Reverse Osmosis Desalination brine as well as potash mine brine is studied. Seawater Reverse Osmosis from the El Prat Desalination Plant and potash mine brine from the Llobregat brine collector pipe were used for this study. These kinds of brines were chemically characterized using different analytical methods that had to be adapted to the hiigh saliniities of the samples. According to the composition results obtained and the literature reviewed, several treatments were evaluated to reach the membrane electrolysis process requirements of the chlor-alkali industry. Potash mine brine had high sodium chloride concentration and in consequence, only purification was studied. Electrodialysis, nanofiltration and precipitation were studied for brines concentration and primary purification. Experiments in the laboratory and in pilot plants were carried out. Pilot plants were designed and operated to determine the optimal conditions to treat the brines and design a feasible system to valorize the brines in the chlor-alkali industry using membrane electrolysis cells. Electrodialysis was demonstrated a feasible technology for SWD-RO brine concentration, as it concentrated the brine and at the same time produced some useful by-products that could be further valorized. Performance obtained was highly dependent on inlet temperature ! and current densities used. The optimal ED operation point was determined when working in a continuous mode at 0.5kA/m2 were 18L/h of 244 g/L NaCl with 0.16 kWh/kg NaCl energy consumption were obtained. A first purification of polyvalent ions was reached using ED. Nanofiltration efficiently removed polyvalent ions from both brines studied. The optimal operation point was around 20 bar in both cases. In the pilot plant, pressures higher than 20bar could not be evaluated due to fixed inlet flow. Removal of sulphates, calcium and magnesium was higher than 90%, 50% and 70% in both brines studied whereas NaCl was only removed by 12% maximum at 20bar, which was benefitial for its reuse. Removal of minor elements was also studied and depended on ionic radii as well as ionic charge. Precipitation using NaOH and Na2CO3 reagents was evaluated to remove calcium and magnesium from the brines at different inlet temperatures. Temperatures over 65ºC increased calcium purification per! formance, especially on SWD-RO brines which contained all the ! antiscala! nts of the RO process that avoided calcium carbonate and sulphate precipitation. In consequence, the amount of reactants needed to reach the optimal purification point was higher than the values reported in the literature. Nevertheless, purifications efficiencies higher than 95% could be obtained. Reactant order addition effect on the purification performance results obtained was not considered significant Precipitates obtained during the purification process could be further valorized.Integration of membrane and precipitation process was needed in order to efficiently treat the brines studied. Finally, a mathematical model to predict the concentration performance and design future experiments was developed and validated with the results obtained in the pilot plant.

Development of strategies for continuous desalination of weak black liquor based on phase-behaviour analysis

A Salt-Rejecting Solar Evaporator for Continuous Steam Generation

Molecular design targets and optimization of low-temperature thermal desalination systems

Brines from industrial water recycling: new ways to resource recovery

Integration of membrane distillation as volume reduction technology for in-land desalination brines management: Pre-treatments and scaling limitations

Lubricant‐Interface Induced Mobile Crystallization for Hypersaline Wastewater Management

Wetting, Scaling, and Fouling in Membrane Distillation: State-of-the-Art Insights on Fundamental Mechanisms and Mitigation Strategies

Conducting thermal energy to the membrane/water interface for the enhanced desalination of hypersaline brines using membrane distillation

Mixed scaling deconstruction in vacuum membrane distillation for desulfurization wastewater treatment by a cascade strategy

A comprehensive assessment of the economic and technical viability of a zero liquid discharge (ZLD) hybrid desalination system for water and salt recovery

Salt-rejecting continuous passive solar thermal desalination via convective flow and thin-film condensation

Dynamic Regulation of Hydrogen Bonding Networks and Solvation Structures for Synergistic Solar-Thermal Desalination of Seawater and Catalytic Degradation of Organic Pollutants

Valorization of brines in the chlor-alkali industry. Integration of precipitation and membrane processes

Multistage Surface-Heated Vacuum Membrane Distillation Process Enables High Water Recovery and Excellent Heat Utilization: A Modeling Study

Engineering Metal–Phenolic Networks for Solar Desalination with Directional Salt Crystallization

Process simulation of ion exchange desalination treatment of coal seam gas associated water

A zero liquid discharge system integrating multi-effect distillation and evaporative crystallization for desalination brine treatment

High Breakthrough Pressure in Hydrogels Enabled Ultrastable Treatment of Hypersaline Wastewaters

Selective recovery of critical materials in supercritical water desalination

Modelling and Optimisation of Multi-Stage Flash Distillation and Reverse Osmosis for Desalination of Saline Process Wastewater Sources

Simultaneous desalination and molecular resource recovery from wastewater using an electrical separation system integrated with a supporting liquid membrane