Cost-Effective Quasi-Parallel Sensing Instrumentation for Industrial Chemical Species Tomography

Godwin Enemali,Rui Zhang,Hugh McCann,Chang Liu
DOI: https://doi.org/10.1109/tie.2021.3063963
IF: 7.7
2022-02-01
IEEE Transactions on Industrial Electronics
Abstract:Chemical species tomography (CST) has been widely applied for the imaging of critical gas-phase parameters in industrial processes. To acquire high-fidelity images, CST is typically implemented by the line-of-sight wavelength modulation spectroscopy measurements from multiple laser beams. In this article, we present a novel quasi-parallel sensing technique and electronic circuits for industrial CST. Although the acquisition and processing of these multiple beams using a fully parallel data acquisition and signal processing system can achieve maximized temporal response in CST, it leads to a highly complex and power-consuming instrumentation with electronics-caused inconsistency between the sampled beams, in addition to a significant burden on data transfer infrastructure. To address these issues, the digitization and demodulation of the multibeam signals in the proposed quasi-parallel sensing technique are multiplexed over the high-frequency modulation within a wavelength scan. Our development not only maintains the temporal response of the fully parallel sensing scheme but also facilitates the cost-effective implementation of industrial CST with very low complexity and reduced load on data transfer compared with the fully parallel sensing technique. The proposed technique was analytically proofed and then numerically examined by noise-contaminated CST simulations. Finally, the designed electronics was experimentally validated using a lab-scale CST system with 32 laser beams.
automation & control systems,engineering, electrical & electronic,instruments & instrumentation
What problem does this paper attempt to address?