A Cascade Fractional-N Synthesizer Topology of DLL and Frequency Multiplier for 5G+ Communication Systems

Kyu-Hyun Nam,Nam-Pyo Hong,Jun-Seok Park

DOI: https://doi.org/10.3390/electronics13234685

IF: 2.9

2024-11-28

Electronics

Abstract:This study presents a synthesizer topology based on a delay-locked loop (DLL) and programmable frequency multiplier for 5G+ communication systems. The proposed synthesizer comprises a 512-phase DLL, an intermediate frequency generator (IFG), and an RF frequency multiplier (RFFM). The 512-phase DLL provides 512 delayed pulses through a chain of 256 delay units and single-to-differential complementary converters (S2DCs). The IFG comprises I/Q-multiplexers, I/Q-accumulators, an XOR, and an S2DC. The I/Q-multiplexer outputs switch to the phase lag or lead waveforms at every rising or falling edge of the outputs, which makes the I/Q-multiplexer output frequency, fMX, programmable. The IF, fIF, is two times fMX, and fIF is up-converted to RF, fRF, through the RFFM. When the reference clock frequency, fref, is 156.25 MHz, the fIF range is 156.863–312.5 MHz and the fRF dynamic range is approximately 1.89–9.96 GHz. The channel resolution range is 3.698–38.609 MHz. Consequently, the proposed synthesizer provides a wide 134% output frequency bandwidth and a finer channel resolution smaller than fref. The presented synthesizer is fabricated in a 65 nm CMOS process. The total power consumption is 15 mW, and the rms jitter integrated from 1 kHz to 100 MHz measured as 107.6 fs.

engineering, electrical & electronic,computer science, information systems,physics, applied