Abstract:Influence of fenugreek gum on bread and in vitro physiological effects This thesis examined the effect of fenugreek gum, from Canadian grown fenugreek on bread quality, when substituted for wheat flour at 5 % and 10 %, and the in vitro physiological effects of these breads, based on models of acute and long-term feeding. Study I determined bread could be produced with 10 % fenugreek gum, while maintaining quality parameters of volume and texture, comparable to a control. This was accomplished through the development of a novel bread production method, using the lamination procedure for puff pastry production. The behavior of fenugreek gum and starch (wheat flour) was determined by rapid visco analysis (RVA), farinograph and dynamic rheological measurement, while scanning electron microscopy of bread found fenugreek gum could be identified within the bread matrix. Study 2 in vitro starch digestion found fenugreek gum at 5 % and 10 % reduced glucose liberated from bread, with 10 % fenugreek gum causing a reduction of over 30 %. RVA of fenugreek breads highlighted differences in viscosity between breads and wheat flour substituted with the gum. This was substantial as viscosity measurements by RVA are conducted on raw ingredients and not the food as consumed, which reflects the possible reduction in viscosity with food processing. This study also determined extruding fenugreek gum may have caused morphological changes to the gum, which may possibly contribute to attenuation of glucose liberated in vitro. Study 3 evaluated the accumulation of short chain fatty acids (SCFA) from the fermentation of three substrates: Extruded fenugreek gum, bread with 10 % extruded gum and control bread, based on ii fecal microbiota from three donors. SCFA profiles varied with substrates and donors, with fenugreek gum having the highest accumulation of SCFA after 12 hours. Donors were a caucuasian Canadian, a black Jamaican and a black Trinidadian who was the only donor culturally exposed to fenugreek. This Trinidadian's SCFA profiles were consistently higher for fenugreek gum than the other donors. These studies collectively showed fenugreek gum, though viscous could be successfully incorporated into bread and have potential as a functional food and nutraceutical.

Technological Evaluation of Methacrylic Acid/Fenugreek Gum Grafted Products as Thickener in Textile Printing

Enhancing the rheological properties of aloe vera polysaccharide gel for use as an eco-friendly thickening agent in textile printing paste

Preparation of Novel Chitosan-Starch Blends as Thickening Agent and Their Application in Textile Printing

Microwave-assisted Synthesis of Acrylamide Grafted Polymeric Blend of Fenugreek Gum and its Characterization

Green synthesis and characterization of carboxymethyl guar gum: Application in textile printing technology

Preparation of polyacrylic acid thickener with electrolyte resistance for carpet ink-jet printing

The Effect of Fenugreek Gum on The Rheological and Qualitative Properties of Pan Bread

Microwave‐assisted synthesis, characterization, and application of tragacanth gum grafted copolymer as bioflocculant for the treatment of textile wastewater using coagulation‐flocculation technique: Swelling behavior and biodegradation studies

Modification of Okra Mucilage with Acrylamide: Synthesis, Characterization and Swelling Behavior

Rheological properties of carboxymethyl hydroxypropyl cellulose and its application in high quality reactive dye inkjet printing on wool fabrics

Rheological Behaviors Of Carboxymethyl Tamarind Gum As Thickener On Georgette Printing With Disperse Dyes

Evaluation of Various Types of Alginate Inks for Light-Mediated Extrusion 3D Printing

Fabrication of Grafted Carboxymethyl Cellulose Superabsorbent Hydrogel for Water Retention and Sustained Release of Ethephon in Sandy Soil

Synthesis, characterization and flocculation efficiency of grafted Moringa gum based derivatives

Microwave induced synthesis of graft copolymer of binary vinyl monomer mixtures onto delignified Grewia optiva fiber: application in dye removal

Synthesis of High-Performance Aqueous Fluorescent Nanodispersions for Textile Printing—A Study of Influence of Moles Ratio on Fastness Properties

Xanthan Gum and Lignin Grafted Chemically Crosslinked Hydrogels for Dye Removal: Synthesis, Characterization and Isotherms Studies

Effects of Graft Modification on the Water Solubility, Apparent Viscosity, and Adhesion of Feather Keratin for Warp Sizing

Preparation of ammonium polyacrylate thickener via inverse emulsion polymerization: paste forming ability and rheological property

THE ADHESIVE CAPACITY OF STARCH GRAFT COPOLYMERS TO POLYESTER / COTTON FIBER

Influence of Fenugreek gum on bread and in vitro physiological effects