Calibration procedure for ultrasonic sensors for precise thickness measurement
Agata Kirjanów-Blazej,Ryszard Błażej,Leszek Jurdziak,Aleksandra Rzeszowska
DOI: https://doi.org/10.2139/ssrn.4292868
2023-03-25
Measurement: Journal of the International Measurement Confederation
Abstract:The conveyor belt, the most expensive element of the conveyor, during many years of operation is subject to complex wear processes related to the processes of its friction against the debris and structural elements, fatigue processes related to its bending on drums and idler sets, and repeated changes in tension when starting the conveyor and passing through the driving drums. The rate of wear processes is proportional to the time and intensity of the belt operation (the number of cycles of the belt loop around the conveyor). Another character, sudden and random, is the belt damage that occurs during the fall of the spoil onto the belt. Smaller lumps accelerate the friction processes by damaging the surface of the covers (rubber cracks, small tears) and intense friction caused by the acceleration of the excavated material. Larger lumps with energy exceeding the limit values cause the belt to puncture through, tearing out parts of the cover or rim, and damage to the core. As the belt wears off, the energy limits decrease (due to the decreasing belt thickness), which significantly accelerates the rate of its degradation processes. Identifying the rate of change in belt thickness over the entire surface is therefore critical to estimating the remaining life of the belt. The implementation of non-invasive diagnostics of conveyor belts to assess the condition of its core and the degree of abrasion allows for a significant reduction in belt operating costs. It can contribute to the extension of its life by reducing uneven wear and damage to the core. The decision to replace the belt at the right moment allows it to be regenerated. Regular control of the condition of damage and abrasions of the belt can prevent the occurrence of major failures and plan the moments of preventive replacements, which are much cheaper than expensive emergency replacements that can additionally cause enormous production losses. Prediction of the replacement of belt sections and their length allows for proper management of the budget allocated to repair and replacement of belts. Thanks to the obtained detailed information on the degree of belt wear, it is possible to take ad hoc corrective actions to extend the life of the belts and to predict the remaining time of its failure-free operation in the adopted replacement strategy. In Poland, at the Wrocław University of Science and Technology, as a result of many years of research work financed by the National Center for Research and Development, diagnostic systems have been developed to assess the technical condition of conveyor belts. One of such devices is the ultrasonic system for continuous belt thickness measurement, which is being built under the LIDER X project, called BeltSonic. This article presents the method of calibrating this device and the obtained measurement accuracy. Accurately measuring the thickness of the strip over its entire surface is critical to forecasting its remaining life.