Effect of inorganic anions on hydrothermal removal of impurities Fe/Al from Cu-bearing polymetallic leachate
Ting Su,Fanrong Kong,Yu Chen,Jiancong Liu,Rui Bian,Suiyi Zhu
DOI: https://doi.org/10.1007/s11356-024-31894-1
IF: 5.8
2024-01-10
Environmental Science and Pollution Research
Abstract:Hydrometallurgy recycling of heavy metals from electroplating sludge is of hot spot in recent decades. Such recycling was tedious in the separation of impure Fe/Al prior to heavy metals from acid leachate after sludge dissolution. Herein, a facile hydrothermal route was developed to separate Fe/Al from Cu-bearing leachate. The results showed that when the leachate was directly hydrothermally treated at 160 °C in the presence of nitrate and ethanol, Al/Cu were stable in the leachate, but nearly 100% Fe was removed as hematite nanoparticles. With the addition of chloridion, the removal efficiencies of Fe/Al/Cu did not change apparently, but the corresponding precipitate was akageneite, not hematite. By replacing chloridion with sulfate, nearly 100% Fe and 98.6% Al were separated as natrojarosite/natroalunite block, while the Cu loss was only 1.7%. However, with the supplementary of phosphate, the Fe/Al removal achieved nearly 100%, but the Cu removal also achieved by 92.6%. The thermodynamic analysis showed that Cu was precipitated rapidly via the phosphate/Cu oxyhydroxide route by adding phosphate but removed slightly via the coordination route on the Fe/Al precipitates with the addition of nitrate, chloridion, and sulfate. In summary, Fe was effectively separated as hematite, akageneite, natrojarosite, and phosphate halite, in the presence of nitrate, chloridion, sulfate, and phosphate, separately. But the removal of Al as natroalunite and AlPO4 only started by adding sulfate and phosphate, respectively. Such results enabled a short hydrometallurgy process to effectively recycle heavy metals from electroplating sludge.Graphical Abstract
environmental sciences