Abstract:Energy harvesting by means of flow-induced vibrations (FIVs) enables continuous supply of power to micro electromechanical systems. Furthermore, FIV is one of the most popular means of energy harvesting. Inspired by wake-induced galloping and aerodynamic changes to a meta-surface structure, a wind-energy harvester (WEH) with a simple structure and high energy density is designed based on FIV (FIV-WEH). Furthermore, the effect of the meta-surface structure on FIV enhancement under elastic interference is discussed. Four experimental models with different heights under an elastic interference are designed: 0.8H cylinder (0.20 m), 0.6H cylinder (0.15 m), 0.4H cylinder (0.10 m), and 0.2H cylinder (0.05 m). The results show that the performance of the 0.6H cylinder is the strongest. It is 116.3% stronger than that of an ordinary cylinder. Based on the experimental models, a series of grooves with different angles is designed, abbreviated as 'Vα', where 'V' indicates that the repeating units are V-shaped and α indicates the centre angle corresponding to the chord length between adjacent repeating units. The addition of a meta-surface structure significantly changes the vibration behaviour of FIV-WEHs. Moreover, the larger the meta-surface structure size, the earlier the coupling vibration region appears. Therefore, the coupling vibration region first appeared on the 'V12' meta-surface, then on the 'V7.2' meta-surface, and finally, on the 'V3.6' meta-surface. A 'peak' phenomenon is observed, and its reason is explained by analysing the frequency. This study also identified a 'coupled vortex-induced vibration' region. Three different shapes of meta-surface structures are designed: 'V', 'T', and 'D' meta-surfaces. The results show that the performance of the 'V' and 'D' meta-surfaces is significantly improved compared to that of a bare cylinder. The 'V' meta-surface can increase the effective wind-speed bandwidth for energy utilization and exhibits the best performance, which is 66.04% higher than that of the 0.6H cylinder. Furthermore, the reason for the enhanced energy-harvesting performance of the 'V' meta-surface is explained through numerical simulations.

Vortex-induced swing (VIS) motion for energy harvesters and flowmeters

A Self-Adaptive Planar Velocity Vector Sensor Based on Vortex-Induced Torsional Swing Motions

The development of Vortex Flowmeter

Vortex-induced vibration triboelectric nanogenerator for energy harvesting from low-frequency water flow

Application of nonlinear stiffness mechanism on energy harvesting from vortex-induced vibrations

Recent advancement of flow-induced piezoelectric vibration energy harvesting techniques: principles, structures, and nonlinear designs

Energy harvesting from flow-induced vibrations enhanced by meta-surface structure under elastic interference

Designed Simulation and Experiment of a Piezoelectric Energy Harvesting System Based on Vortex-Induced Vibration

Improved VIV energy harvesting with a virtual damper–spring system

Experimental and Numerical Research on the Viscous Flow Field Induced by a Swing Plate

Analysis on flow-induced vibration of square cylinders with different vibration forms and the flow energy harvesting capacity

A study of mass flow rate measurement based on the vortex shedding principle

Development of a vortex flowmeter with good performance at low-flowrate

An electromagnetic vibro-impact nonlinear energy sink for simultaneous vibration suppression and energy harvesting in vortex-induced vibrations

Vortex-induced vibration of flexible riser transporting high-speed spiral flow in deep-sea mining

Energy harvesting in a flow-induced vibrating flapper with biomimetic gaits

Harnessing flow-induced vibrations for energy harvesting: Experimental and numerical insights using piezoelectric transducer

Enhancement of low-speed piezoelectric wind energy harvesting by bluff body shapes: Spindle-like and butterfly-like cross-sections

Vortex-induced vibration of a flexible pipe under oscillatory sheared flow

A vortex-induced vibration device based on MG-TENG and research of its application in ocean current energy harvesting