Abstract:Results are presented for modelling of the evaporation and magnetron sputter deposition of Zn(x)O(y) onto an O-terminated ZnO (0001¯) wurtzite surface. Growth was simulated through a combination of molecular dynamics (MD) and an on-the-fly kinetic Monte Carlo (otf-KMC) method, which finds diffusion pathways and barriers without prior knowledge of transitions. We examine the effects of varying experimental parameters, such as substrate bias, distribution of the deposition species and annealing temperature. It was found when comparing evaporation and sputtering growth that the latter process results in a denser and more crystalline structure, due to the higher deposition energy of the arriving species. The evaporation growth also exhibits more stacking faults than the sputtered growth. Post-annealing at 770 K did not allow complete recrystallization, resulting in films which still had stacking faults where monolayers formed in the zinc blende phase, whereas annealing at 920 K enabled the complete recrystallization of some films to the wurtzite structure. At the latter temperature atoms could also sometimes be locked in the zinc blende phase after annealing. When full recrystallization did not take place, both wurtzite and zinc blende phases were seen in the same layer, resulting in a phase boundary. Investigation of the various distributions of deposition species showed that, during evaporation, the best quality film resulted from a stoichiometric distribution where only ZnO clusters were deposited. During sputtering, however, the best quality film resulted from a slightly O rich distribution. Two stoichiometric distributions, one involving mainly ZnO clusters and the other involving mainly single species, showed that the distribution of deposition species makes a huge impact on the grown film. The deposition of predominantly single species causes many more O atoms at the surface to be sputtered or reflected, resulting in an O deficiency of up to 18% in the deposited film and therefore resulting in more stacking faults and phase boundaries. The methods used allow analysis of key mechanisms that occur during the growth process and give hints as to the optimum conditions under which complete crystalline layers can form.

Impact of high substrate temperature on pulsed laser deposited ZnO pillars: A technological route to investigate the structural, optical and superhydrophilic properties

The growth of nanoscale ZnO films by pulsed-spray evaporation chemical vapor deposition and their structural, electric and optical properties

A Facile Method to Fabricate Superhydrophobic ZnO Nanostructure with Petal Effect

Effect of Reaction Temperature on Surface Morphology and Photoelectric Properties of ZnO Grown by Hydrothermal Method in Mixed Solvent

Effect of substrate temperature on (00l) oriented growth of ZnO nanostructures on fused quartz substrate by PLD

Influence of Substrate Temperature on the Structure and Optical Properties of ZnO Thin Films Grown by Pulsed Laser Deposition

A comparative study of optical, reversible wettability and UV light sensitivity of ZnO nano-structures via chemical methods

Surface energy and stress driven growth of extremely long and high-density ZnO nanowires using a thermal step-oxidation process

Superhydrophobic surfaces based on ZnO-constructed hierarchical architectures

Influences of Substrate Temperature on the Crystalline Characteristics and Optical Properties for ZnO Films Deposited on Freestanding Thick Diamond Films

The influence of post-growth heat treatment on the optical properties of pulsed laser deposited ZnO thin films

Microstructure and Photoluminescence Properties of ZnO Thin Films Prepared by Pulsed Laser Deposition

Improved optical absorption, enhanced morphological and electrochemical properties of pulsed laser deposited binary zinc and vanadium oxide thin films

Structural and morphological changes with substrate heating in zinc films synthesized by thermal vapor deposition technique

Effect of Deposition Temperature on Morphological, Optical, and Photocatalytic Properties of ZnO Thin Films Synthesized by Ultrasonic Spray Pyrolysis Method

Atomic Layer Deposition of Zinc Oxide Films: Effects of Nanocrystalline Characteristics on Tribological Performance

Structural and Optical Properties of Highly (110)-Oriented Non-Polar ZnO Evaporated Films on Si Substrates

Epitaxial growth of ZnO films on (100) and (001) γ-LiAlO 2 substrates by pulsed laser deposition

Modelling the growth of ZnO thin films by PVD methods and the effects of post-annealing

Epitaxial Growth Of Zno Films On (100) And (001) Gamma-Lialo2 Substrates By Pulsed Laser Deposition

Modification of surface morphology and lattice order in nanocrystalline ZnO thin films prepared by spin-coating sol–gel method