Abstract:Muon imaging technology has developed rapidly over the past decades with extensive applications. In many cases, plastic scintillator detectors are preferred because of their high cost performance, ease of processing and robustness in harsh environments. To reduce imaging time and improve imaging quality, detectors tend to have large areas and high position resolutions. The challenge to the electronics for such detectors is to maintain the scale of electronics acceptable while improving the high position resolution of the detector. In this paper, the basic detector unit is a triangular strip of plastic scintillator, each embedded with two wavelength-shifting (WLS) fibers read out by the silicon photomultipliers (SiPMs). Since the hit position of muon on the detector is determined by the splitting ratio of the scintillation light on two adjacent scintillator strips, it is necessary the readout electronics has high linearity and low noise. The possibility of the electronics channel multiplexing on the same detector plane is fully explored so that four WLS fibers can be read out by one SiPM realizing 2:1 readout channel compression. Furthermore, since multiple electronics modules are connected by a daisy chain structure, the electronics system is very scalable with its data acquisition system (DAQ) independent of detector size. In addition to detailing the position encoding readout scheme, the design of electronics module and the DAQ system, the electronics system has been implemented and applied to a prototype detector for performance evaluation. Using scintillator strips with 11 mm pitch size, the position resolution of the detector reaches 1.49 mm, which demonstrates that the designed electronics is suitable for the new detector structure, and the combination of the two has a good application prospect in muon imaging.

Readout electronics of a muon beam monitor for the phase-α of the COMET experiment

Development of a Scintillating-Fiber-based Beam Monitor for the Coherent Muon-to-electron Transition Experiment

Development of a SciFi-based beam monitor for COMET

Design and Measurement of Signal Processing System for Cavity Beam Position Monitor

Development of readout electronics a novel beam monitoring system for ion research facility accelerator

Readout Electronics Design for a Cosmic Ray Muon Imaging System

Full-Scale Readout Electronics for the ECHo-100k Experiment

Development of the Readout Electronics for a MAPS-Based Beam Telescope

Electronics design for a muon imaging system using triangular plastic scintillators with WLS fiber readouts

Development of a 256-channel Time-of-flight Electronics System For Neutron Beam Profiling

Performance of Scintillator Counters with Silicon Photomultiplier Readout

A search for a muon to electron conversion in COMET

Position Encoding Readout Electronics Of Large Area Micromegas Detectors Aiming For Cosmic Ray Muon Imaging

Readout Electronics for CBM-TOF Super Module Quality Evaluation

Simulation Studies of the Beam Monitor for the CSR External-Target Experiment

Readout System for a Prototype Multi-Purpose Time Projection Chamber at CSNS Back-n

40 MHz readout of CMS silicon modules in a high intensity beam

Beam phase monitor system design for 100 mev cyclotron

Design of a 32-Channel NIM TDC Module Based on Single FPGA for the Μsr Spectrometer Prototype at the China Spallation Neutron Source

High efficiency muon registration system based on scintillator strips

Development of a Time-of-Flight Electronics System for Neutron Beam Profiling at CSNS-WNS