Abstract:Cable supported bridges are typically part of community-critical infrastructure and therefore the consequences arising from extensive structural damage due to a fire and the subsequent operational discontinuity could be significant beyond the damage to the bridge itself and the cost of repairs. Bridge design standards generally do not provide guidance and hence fire resistance requirements are often informed by first principles assessments of the thermal and structural response of the structure to proposed fire scenarios. A deterministic assessment can provide a reasonable worst-case scenario but it does not allow bridge stakeholders to make informed decisions with regards to uncertainty and the low likelihood of fires occurring to identify the benefits of investments in structural fire protection. This is because the target reliability required for each bridge may be different depending on its characteristics, and the expected fire severity has a probabilistic nature. This research aims to fill this gap by undertaking a reliability-based analysis to assess the probability of structural failure by considering the probability of a fire of a given size occurring and the uncertainty in the incident location and wind. The methodology is demonstrated through the case study of an operational 450 m long cable supported bridge section and a fire scenario based on a liquid fuel tanker. Liquid tankers can result into two type of fire scenario: first, a fire being contained within the tanker; and secondly, a fire due to a pool on the deck. Both fire scenarios have been characterised and it was determined that the contained tanker scenario presents a more onerous design case owing to its more prolonged duration. A Monte Carlo analysis was undertaken for a total of 10,000 independent trials of the combination of the location of the fire and the wind direction. The frequency of the fire was also examined to establish the probability of structural failure of a cable. It was established that the inclusion of wind can sometimes reduce the estimated height at which cables may experience temperatures with the potential to cause cable failure. However, for a number of the cases, the estimated height can remain broadly similar (i.e. within a couple metres difference) to the worst-case calculated value. Based on this analysis, the influence of the required level of reliability as well the fire protection duration specification agreed with bridge stakeholders can be used to determine the height at which cable fire protection is necessary to reduce the probability of structural failure to a level acceptable to the stakeholders. This approach allows bridge designers and stakeholders to make informed decisions with regards to provision and extent of fire preventive/protective measures for cable supported bridges.

Post-fire assessment of composite steel-concrete box-girder bridges: Lessons from a recent incident

Experimental Study and Numerical Analysis of A Composite Bridge Structure

Safety Control Research of Steel U Girder of Composite Bridge with Incremental Launching Construction

Performance investigation of highway bridge pier columns under the sequential effects of fire followed by vehicle collision and subsequent air blast: A numerical investigation

Damage Detection and Safety Assessment on Bridge 5tructure after Fire Accident

Performance of steel cable-stayed bridges in ship fires, part I: Numerical method and baseline fire scenario study

Integrating fire safety into bridge design is essential for resilient infrastructure

Multi-Hazard Assessment of Bridges in Case of Hazard Chain: State of Play and Application to Vehicle-Pier Collision Followed by Fire

Parametric fire curves for I-girder bridges submitted to under deck tanker fires

Evaluation and Reinforcement of Prestressed Concrete Hollow Slab Bridge after Fire Damage

Performance of steel cable-stayed bridges in ship fires, Part II: Influencing factors and mechanisms

Static and Dynamic Performance Analysis of Cable-Stayed Bridges with Cables Damaged Fire

Fire-induced collapse of an I-95 overpass in Philadelphia: Causes, collapse mechanism, and mitigation strategies

A Study on the Thermodynamic Response of Double-Armed Thin-Walled Piers under an FRP Anti-Collision Floating Pontoon Fire

Numerical analysis-based structural behavior assessment of a cable-stayed bridge under tanker fire

Effect of Deck Deterioration on Overall System Behavior, Resilience and Remaining Life of Composite Steel Girder Bridges

Assessment of a fire-damaged concrete overpass: the Verona bus crash case study

A Simulation-Based Investigation on Thermal Responses of Suspension Bridge Tower Under Different Fire Scenarios

Reliability-based Fire Protection of Structural Cables due to Deck Fires on Cable Supported Bridges

Behavior of steel-ECC composite bridges under post-fire conditions

In-service performance assessment of fire-corrosion damaged cables of bridges