Surface engineering with ionic polymers on membranes for boron removal

DOI: https://doi.org/10.1007/s11705-024-2413-5

IF: 4.803

2024-04-24

Frontiers of Chemical Science and Engineering

Abstract:Removal of boric acid from seawater and wastewater using reverse osmosis membrane technologies is imperative and yet remains inadequately addressed by current commercial membranes. Existing research efforts performed post-modification of reverse osmosis membranes to enhance boron rejection, which is usually accompanied by substantial sacrifice in water permeability. This study delves into the surface engineering of low-pressure reverse osmosis membranes, aiming to elevate boron removal efficiency while maintaining optimal salt rejection and water permeability. Membranes were modified by the self-polymerization and co-deposition of dopamine and polystyrene sulfonate at varying ratios and concentrations. The surfaces became smoother and more hydrophilic after modification. The optimum membrane exhibited a water permeability of 9.2 ± 0.1 L·m −2 ·h −1 ·bar −1 , NaCl rejection of 95.8% ± 0.3%, and boron rejection of 49.7% ± 0.1% and 99.6% ± 0.3% at neutral and alkaline pH, respectively. The water permeability is reduced by less than 15%, while the boron rejection is 3.7 times higher compared to the blank membrane. This research provides a promising avenue for enhancing boron removal in reverse osmosis membranes and addressing water quality concerns in the desalination process.

engineering, chemical