Pyrolysis of typical solid wastes in a continuously operated microwave-assisted auger pyrolyser: Char characterization, analysis and energy balance
Chunbao Zhou,Zeyu Deng,Yingwen Zhang,Xueguang Li,Yang Liu,Jie Fu,Lei Chen,Yanxin Yuan,Yajie Jin,Jianjun Dai,Mengyan Yu,Changfa Zhang,Chenglong Liu,Wenya Ao,Yan Li
DOI: https://doi.org/10.1016/j.jclepro.2022.133818
IF: 11.1
2022-11-01
Journal of Cleaner Production
Abstract:Four typical solid wastes (textile dyeing sludge (TDS), municipal sewage sludge (MSS), furfural residue (FR), and wood sawdust (WS)) were pyrolysed by continuously operated auger reactor under microwave irradiation. This study compared the basic characteristics (e.g., elemental composition, metallic and non-metallic contents, chemical functional groups, crystalline phases and surface properties) and adsorption performances (methylene blue, crystal violet and iodine) of chars from two sludges and two lignocellulosic biomass at different temperatures. Compared with FR and WS, pyrolysis of TDS and MSS achieved higher char yields (>60 wt%) and lower contents of C and H. Regardless of solid wastes types, increasing pyrolysis temperature reduced chars yield, and decreased the abundance of –OH functional group and H/C and O/C ratios. Biochar (WS, 750 °C) had the lowest H/C (0.2) and O/C (0.01). The optimal adsorption capabilities of MB (methylene blue), CV (crystal violet), and iodine of chars were 161.88 mg/g (TDS, 450 °C), 93.85 mg/g (TDS, 750 °C), and 266.81 mg/g (FR, 750 °C), respectively. The performance of sludge chars to remove MB and CV were superior, even better than other adsorbents in the literatures. Chars from solid wastes can act as adsorbents in wastewater treatment and have good application prospects. The maximum energy yield of 90.67% was found for WS, and the maximum energy efficiency of 66.16% was observed for FR at 650 °C.
environmental sciences,green & sustainable science & technology,engineering, environmental