Abstract:A comprehensive numerical and experimental investigation on micrometer-sized water droplet impact dynamics and evaporation on an unheated, flat, dry surface is conducted from the standpoint of spray-cooling technology. The axisymmetric time-dependent governing equations of continuity, momentum, energy, and species are solved. Surface tension, wall adhesion effect, gravitational body force, contact line dynamics, and evaporation are accounted for in the governing equations. The explicit volume of fluid (VOF) model with dynamic meshing and variable-time stepping in serial and parallel processors is used to capture the time-dependent liquid-gas interface motion throughout the computational domain. The numerical model includes temperature- and species-dependent thermodynamic and transport properties. The contact line dynamics and the evaporation rate are predicted using Blake's and Schrage's molecular kinetic models, respectively. An extensive grid independence study was conducted. Droplet impingement and evaporation data are acquired with a standard dispensing/imaging system and high-speed photography. The numerical results are compared with measurements reported in the literature for millimeter-size droplets and with current microdroplet experiments in terms of instantaneous droplet shape and temporal spread (R/D(0) or R/R(E)), flatness ratio (H/D(0)), and height (H/H(E)) profiles, as well as temporal volume (inverted A) profile. The Weber numbers (We) for impinging droplets vary from 1.4 to 35.2 at nearly constant Ohnesorge number (Oh) of approximately 0.025-0.029. Both numerical and experimental results show that there is air bubble entrapment due to impingement. Numerical results indicate that Blake's formulation provides better results than the static (SCA) and dynamic contact angle (DCA) approach in terms of temporal evolution of R/D(0) and H/D(0) (especially at the initial stages of spreading) and equilibrium flatness ratio (H(E)/D(0)). Blake's contact line dynamics is dependent on the wetting parameter (K(W)). Both numerical and experimental results suggest that at 4.5 < We < 11.0 the short-time dynamics of microdroplet impingement corresponds to a transition regime between two different spreading regimes (i.e., for We < or = 4.5, impingement is followed by spreading, then contact line pinning and then inertial oscillations, and for We > or = 11.0, impingement is followed by spreading, then recoiling, then contact line pinning and then inertial oscillations). Droplet evaporation can be satisfactorily modeled using the Schrage model, since it predicts both well-defined transient and quasi-steady evaporation stages. The model compares well with measurements in terms of flatness ratio (H/H(E)) before depinning occurs. Toroidal vortices are formed on the droplet surface in the gaseous phase due to buoyancy-induced Rayleigh-Taylor instability that enhances convection.

Impingement dynamics of [EMIm]Ac ionic liquid drops on heated porous surfaces

Dynamic study of [Emim]Ac ionic liquid droplet impact on mildly heated solid surfaces

Isobaric Vapor–Liquid Equilibria for Water + Acetic Acid + 1-Ethyl-3-methylimidazolium Diethylphosphate at 101.32 Kpa

Study on Interfacial Mass Transport and Process Intensification for Ionic Liquid [bmim]br Synthesis

Dynamics of drops on hygroscopic ionic liquid aqueous solution-wetted porous surfaces

Impingement dynamics of droplets on mildly heated walls at initial and later stages

Universality of Droplet Impingement: Low-to-High Viscosities and Surface Tensions

Mass Transfer Thermodynamics through a Gas-Liquid Interface

Experimental study of single droplet impingement on a thin liquid film under a non-uniform electric field

Analytical Consideration of Liquid Droplet Impingement on Solid Surfaces

Micrometer-sized water droplet impingement dynamics and evaporation on a flat dry surface

Quantification of the impact of water on the wetting behavior of hydrophilic ionic liquid: a molecular dynamics study

Effect of rheology and interfacial tension on spreading of emulsion drops impacting a solid surface

Splash characteristics and mechanics upon drop impingement on a low-temperature surface

Wetting and electro-wetting behaviors of [Bmim] [Bf4] ionic liquid droplet on lyophobic and lyophilic solid substrates

Effect of wettability on droplet impact: Spreading and splashing

Experimental study on impact patterns and dynamics characteristics of NaCl water droplet with different concentrations on heated surface

Experiment Study on Adhesion Dynamic Characteristics of Droplet Impacting on an Inclined Heated Surface

Molecular Insights into the Electrowetting Behavior of Aqueous Ionic Liquid

Numerical study on jet and stretch behaviors of an impingement leaky-dielectric droplet under electric field

Experimental Investigation of Velocity and Temperature Distribution Inside Single Droplet Impingement on a Heated Substrate