Abstract:OBJECTIVE:To study the two metal catalysts Ag/Al2O3 and Cu/Al2O3 that interdict the transmission pathway for SARS and other respiratory infectious diseases.METHODS:Two metal catalysts Ag/Al2O3 and Cu/Al2O3 were pressed into wafers. One hundred microL 10(6) TCID50/mL SARS-CoV, 100 microL 10(6) PFU/mL recombinant baculovirus expressing hamster's prion protein (haPrP) protein and roughly 10(6) E. coli were slowly dropped onto the surfaces of the catalyst wafers and exposed for 5 and 20 min, respectively. After eluted from the surfaces of wafers, the infectivity of viruses and propagation of bacteria were measured. The expression of PrP protein was determined by Western blot. The morphological changes of bacteria were observed by electronic microscopy.RESULTS:After exposure to the catalysts surfaces for 5 and 20 min, the infectivity of SARS-CoV in Vero cells and baculovirus in Sf9 cells dropped down to a very low and undetectable level, and no colony was detected using bacteria culture method. The expression of haPrP protein reduced to 21.8% in the preparation of Sf9 cells infected with recombinant baculovirus exposed for 5 min and was undetectable exposed for 20 min. Bacterial membranes seemed to be cracked and the cytoplasm seemed to be effluent from cell bodies.CONCLUSION:Exposures to the surfaces of Ag/Al2O3 and Cu/Al2O3 destroy the replication and propagation abilities of SARS-CoV, baculovirus and E. coli. Inactivation ability of metal catalysts needs to interact with air, utilizing oxygen molecules in air. Efficiently killing viruses and bacteria on the surfaces of the two metal catalysts has a promising potential for air-disinfection in hospitals, communities, and households.

Effect of the Photocatalyst under Visible Light Irradiation in SARS-CoV-2 Stability on an Abiotic Surface.

Inactivation of various variant types of SARS-CoV-2 by indoor-light-sensitive TiO2-based photocatalyst

SARS-CoV-2 Disinfection of Air and Surface Contamination by TiO2 Photocatalyst-Mediated Damage to Viral Morphology, RNA, and Protein

Light-Induced Transformation of Virus-Like Particles on TiO2

Inactivation of SARS-CoV-2 and Photocatalytic Degradation by TiO2 Photocatalyst Coatings

Inactivation of Human Coronavirus by Titania Nanoparticle Coatings and UVC Radiation: Throwing Light on SARS-CoV-2

Photocatalytic Inactivation of Viruses and Prions: Multilevel Approach with Other Disinfectants

Inactivation of SARS-CoV-2 variants by nitrogen-doped titanium dioxide loaded with metals as visible-light photocatalysts

SARS-CoV-2 Survival on Surfaces and the Effect of UV-C Light

SARS-CoV-2 inactivation by ultraviolet radiation and visible light is dependent on wavelength and sample matrix

Efficient and Quick Inactivation of SARS Coronavirus and Other Microbes Exposed to the Surfaces of Some Metal Catalysts.

UV-C irradiation-based inactivation of SARS-CoV-2 in contaminated porous and non-porous surfaces

Deactivation of SARS-CoV-2 with pulsed-xenon ultraviolet light: Implications for environmental COVID-19 control

Inactivation characteristics of a 280 nm Deep-UV irradiation dose on aerosolized SARS-CoV-2

Inactivation Activities of Ozonated Water, Slightly Acidic Electrolyzed Water and Ethanol against SARS-CoV-2

Photo-catalyzed TiO2 Inactivates Pathogenic Viruses by Attacking Viral Genome

Rapid and complete inactivation of SARS-CoV-2 by ultraviolet-C irradiation

The effect of temperature on persistence of SARS-CoV-2 on common surfaces

Disinfection of SARS-CoV-2 using UVC reveals wavelength sensitivity contributes towards rapid virucidal activity

Virus Behavior after UV254 Treatment of Materials with Different Surface Properties

Inactivation of SARS-CoV-2 in serum using physical methods