Abstract:In this study, sorptivity, setting time, resistance to sulfuric acid, and compressive strength of mortars that use alkali-activated GGBS and fly ash as binders, were evaluated experimentally. The activation of binders, was achieved at room temperature of 22 ± 2 °C using combinations of sodium silicates (Na2SiO3) and sodium hydroxide (NaOH) solutions in ratios of 1.5, 2.0, and 2.5. The parameters considered in terms of their effects on fresh and hardened properties include: NaOH molarity, activator ratio Na2SiO3/NaOH, mortar sample age, and relative amount of GGBS/fly ash in binder combination. Sorptivity, change in mass, and compressive strength were determined for mortar samples that were submerged in 10% sulfuric acid solution for 7 days, 28 days, and 90 days. The binder for mortar samples tested at each of the specified ages consisted of 100% GGBS (G100), 75%GGBS+25% fly ash (G75F25), or 50% GGBS + 50% fly ash (G50F50). The binder was activated using Na2SiO3 solution, combined with 10 M, 12 M, 14 M, or 16 M NaOH solution. It was found that sorptivity decreases with increase in curing age, for all activator ratios, concentrations, and relative amounts of GGBS/fly ash. Binder consisting of 75%GGBS + 25% fly ash with NaOH concentration of 12 M had the lowest sorptivity. Exposure of alkali-activated GGBS/fly ash mortar samples to sulfate attack did not cause loss in mass nor visible signs of damage/deterioration. All binder combinations experienced increase in compressive strength after curing in 10%sufluric acid solution, with the optimum G75F25 mix achieving a 28-day strength of 80.53 MPa when NaOH molarity is 10 M, which increased to 91.06 MPa after 90 days. Variation in concentration of NaOH didn’t cause significant change in the magnitudes of 28-day or 90-day compressive strengths of G50F50. However, despite slow dissolution of fly ash and immersion in 10% sulfuric acid solution, G50F50 developed 28-day compressive strength of 56.23 MPa and 90-day compressive of 86.73 MPa, which qualifies G50F50 as high strength mortar for practical purposes.

Development of lime-pozzolan green binder: The influence of anhydrous gypsum and high ambient temperature curing

Development of eco-friendly binder using metakaolin-fly ash–lime-anhydrous gypsum

Performance of Green Binder Developed from Flue Gas Desulfurization Gypsum Incorporating Portland Cement and Large-Volume Fly Ash

Preparation and curing method of red mud-calcium carbide slag synergistically activated fly ash-ground granulated blast furnace slag based eco-friendly geopolymer

Lime activated flyash-phosphogypsum blend as a low-cost alternative binder

Energy efficient cement free binder developed from industry waste – A sustainable approach

Cementitious binder of phosphogypsum and other materials

Setting and Hardening Behaviour of Alkali-Activated Landfilled Fly Ash–Slag Binder at Room Temperature

Cementitious binder derived with fluorogypsum and low quality of fly ash

The Impact of Fly Ash on the Properties of Cementitious Materials Based on Slag-Steel Slag-Gypsum Solid Waste

Design and characterization of iron–calcium–aluminium–silicate–hydrate as low-temperature binder

Development of an eco-friendly geopolymer mortar using slag and fly ash with high bentonite content for thermal and environmental applications

Static Compaction on Coupled Precursors and Optimizing Molarity for Enhanced Strength and Durability of Geopolymer

Improving the Characteristics of Less Active Geopolymer Binders Utilizing Ground Granulated Blast-Furnace Slag under Different Curing Conditions

Influence of solid waste gypsum and additives on the properties of sulfoaluminate cement-fly ash-gangue ternary binder

Hydration, mechanical properties and microstructure of lime-pozzolana pastes by recycling waste sludge ash under marine environment

Effects of the Curing Regime, Acid Exposure, Alkaline Activator Dosage, and Precursor Content on the Strength Development of Mortar with Alkali-Activated Slag and Fly Ash Binder: A Critical Review

Alkali-Activated Binders as Sustainable Alternatives to Portland Cement and Their Resistance to Saline Water

Microstructure and properties of the binder of fly ash-fluorogypsum-Portland cement

Development of ternary blend cement-free binder material for construction

Fresh Properties and Sulfuric Acid Resistance of Sustainable Mortar Using Alkali-Activated GGBS/Fly Ash Binder