Abstract:This paper describes a mechanical model of the mid‐ocean ridge axis based on a nonlinear rheology. The oceanic lithosphere is modeled as a strongly temperature‐dependent “power law” material with the Byerlee's friction law describing the brittle behavior of the upper oceanic lithosphere. We examined two simple models. A mantle‐only model predicted an axial rift valley 1–2 km deep and 10–15 km wide at slow half‐rates of 5–25 mm/yr which is in fair agreement with observations. However, the rift valley did not completely vanish at fast spreading rates even though its width and relief became much smaller. Thus, the mantle‐only model failed to explain the observed transition in axial topography with spreading rate. By including a uniform thickness oceanic crust with theological properties different from the mantle, our second model produced the first order variation of axial topography with spreading rate: a pronounced rift valley with 1–2 km relief at slow rates, a smaller relief (<500 m) rift valley at intermediate rates, and no rift valley at fast rates. There are two additional results of the nonlinear rheology model which are distinctively different from the previous uniform viscosity mantle models. First, horizontal velocity at the seafloor changes sharply in a very narrow zone at the ridge axis, i.e., the stresses are concentrated in a very narrow zone for the nonlinear rheology. This conclusion is remarkably independent of the boundary conditions at the seafloor. Second, the computed width of the axial plastic failure zone decreases with spreading rate, a result very different from that of a uniform viscosity model. This is caused by the strong temperature dependence of the power law rheology and the fact that the temperature of the oceanic lithosphere depends greatly on the spreading rate. Beyond some distance from the ridge axis, the brittle plate (roughly the region above the 750°C isotherm) deforms very little; both the horizontal strain rate ė11 and the maximum shear strain rate ėmax are less than 10−17 s−1 which is in good agreement with the 10−18 s−1 average for oceanic brittle plate deformation inferred from seismic moment data. Within the ductile region (area beneath the 750°C isotherm) the strain rates are in the range of 10−14–10−16 s−1, except within a narrow band near the ridge axis where higher strain rates are located. We found that the thermal structure of the oceanic lithosphere is not very sensitive to the details of the mantle flow pattern (or the rheology) but is very sensitive to the cooling by hydrothermal circulation near the ridge axis. Axial structure is also influenced by factors other than the spreading rate. Within the range of slow and intermediate rates, our calculations show that the size of an axial rift valley decreases with an increase in either the thickness of the oceanic crust or the mantle temperature; in other words, a thinner crust or a cooler mantle temperature will produce a more pronounced rift valley. In the vicinity of hotspots, the absence of an axial rift valley even at slow spreading rates, such as the Reykjanes Ridge, can be well explained by the anomalously thicker crust and higher mantle temperatures. In contrast, at the Australian‐Antarctic Discordance a deeper than normal section of an intermediate spreading ridge has very rough topography not present on the adjacent sections of the ridge; this can be explained by our model as due to an anomalously low mantle temperature as has been suggested or perhaps also due to a thinner oceanic crust

Mid-ocean ridge unfaulting revealed by magmatic intrusions

Magmato-tectonic Mechanism of Southwest Indian Ridge (49°-50°E) Inferred from Quantitative Morphotectonic Analysis Based on High-Resolution Multibeam Bathymetry

The crustal nature of the northern Mozambique Ridge, Southwest Indian Ocean

The Mechanism of Tidal Triggering of Earthquakes at Mid-Ocean Ridges

How Hydrothermal Cooling and Magmatic Sill Intrusions Control Flip‐Flop Faulting at Ultraslow‐Spreading Mid‐Ocean Ridges

Unraveling the link between magma and deformation during slow seafloor spreading

Detachment-controlled Subsidence Pattern at Hyper-extended Passive Margin: Insights from Backstripping Modelling of the Baiyun Rift, Northern South China Sea

Rift Valley/no Rift Valley Transition at Mid‐ocean Ridges

Morphotectonic Evolution of Passive Margins Undergoing Active Surface Processes: Large‐Scale Experiments Using Numerical Models

Magma-induced tectonics at the East Pacific Rise 9°50'N: Evidence from high-resolution characterization of seafloor and subseafloor

Tectono‐sedimentary evolution of high‐displacement crustal‐scale normal faults and basement highs on rifted margins: Klakk Fault Complex and Frøya High, Mid‐Norwegian Margin

Normal fault reactivation during multiphase extension: Analogue models and application to the Turkana depression, East Africa

A Nonlinear Rheology Model for Mid‐ocean Ridge Axis Topography

Sequential faulting explains the asymmetry and extension discrepancy of conjugate margins

A Quantitative Method for Active Fault Migration Distance Assessment on Both Sides of Mid-Ocean Ridges-Based on Multi-Beam Data

Local Seismicity and Sediment Deformation in the West Svalbard Margin: Implications of Neotectonics for Seafloor Seepage

Spatial Variations in the Degree of Upper‐Mantle Depletion in a Mid‐Ocean Ridge–Transform Fault System

Long live the fault! Double inversion of a Mesozoic rift‐related fault system in the central Apennines

Microseismicity Around Loki's Castle Hydrothermal Vent Field Reveals the Early Stages of Detachment Faulting at the Mohns‐Knipovich Ridge Intersection

Transitions in Subduction Zone Properties Align with Long-Term Topographic Growth (cascadia, USA)

Interactions between propagating rifts and linear weaknesses in the lower crust