Abstract:Publication date: 30 March 2021 Source: Materials Science Forum Vol. 1025 Author(s): Muhammad Syafiq Mohd Shafei, Zulkifly Jemaat Recent advancement on biological wastewater treatment is via granular sludge technology. It is widely known that, aerobic granular sludge has been developed in a batch operation since its discovery. Yet, most of the wastewater treatment plant (WWTP) is operated in continuous mode. Now, the real challenge is how to adopt the granular technology while maintaining present operation mode of WWTP. Thus, this study attempts to evaluate the feasibility of developing aerobic granular sludge in continuous airlift reactors feed with two different substrates, namely glucose and acetate. Two identical airlift reactors (6 L) were employed and operated at room temperature (30°C). Prior to the substrate feeding, both reactors were inoculated with seed sludge obtained from a palm oil mill anaerobic pond. One of the reactors was fed with 2000 mg COD L-1 of glucose (ALR1) and the other reactor with 2000 mg COD L-1 of acetate (ALR2). The hydraulic retention time (HRT) and organic loading rate (OLR) for both reactors were maintained at 4 days and between 0.2 to 0.5 kg m-3day-1 respectively. Dissolved oxygen was maintained between 5.0 and 6.0 mg O2L-1 and supplied by air compressor. The reactor performance was monitored based on COD removal. Aerobic granules developed throughout the study period was evaluated based on granules size and morphology, sludge volumetric index (SVI30) and SVI5/SVI30 ratio analysis. Results showed that ALR1 demonstrated the formation of filamentous-type aerobic granules with most of the SVI30 average at 100 to 190 mL g-1. Ratio SVI5/SVI30 analysis was evaluated at 0.2 and 0.5. The largest granules size obtained during the experiment was about 600 μm on day-136 and average granules size obtained at 200 to 400 μm. ALR1 able to achieve 95% COD removal. For ALR2, round shaped aerobic granules were developed with average SVI30 from 100 to 1000 mLg-1. SVI5/SVI30 analysis indicated an average ratio between 0.7 and 0.9. The average granules size was between 30 to 50 μm and the largest was 78 μm on day-60. 90% of COD removal efficiency was obtained in ALR2. In conclusion, ALR fed with acetate had indicated better aerobic granules characteristics as compared to glucose fed reactor. Furthermore, the study demonstrated that to develop aerobic granules in continuous reactors is feasible.

Aerobic granulation in an oxidation ditch using the residual sludge after extracting slime-extracellular polymer substances

Rapid aerobic sludge granulation in an integrated oxidation ditch with two-zone clarifiers.

A Case for Aerobic Sludge Granulation: from Pilot to Full Scale

Enhanced aerobic granulation with extracellular polymeric substances (EPS)-free pellets.

Rapid granulation of aerobic sludge in a continuous-flow reactor with a two-zone sedimentation tank by the addition of dewatered sludge

Coupling of sponge fillers and two-zone clarifiers for granular sludge in an integrated oxidation ditch

Granulation and Characteristics of Extracellular Polymers of Anammox Sludge in High-Load EGSB Reactor

Continuous flow aerobic granular sludge: recent developments and applications

Enhanced aerobic sludge granulation by applying carbon fibers as nucleating skeletons

ENHANCEMENT OF AEROBIC GRANULATION BY A NOVEL SLUDGE SELECTION STRATEGY TREATING LOW-STRENGTH WASTEWATER

Development of a dynamic feeding strategy for continuous-flow aerobic granulation and nitrogen removal in a modified airlift loop reactor for municipal wastewater treatment

Aerobic Sludge Granulation in a Full-Scale Sequencing Batch Reactor

Aerobic granulation in sequential sludge blanket reactor

Promoting the Granulation Process of Aerobic Sludge Via a Sustainable Strategy of Effluent Reflux in View of AHLs-mediated Quorum Sensing

Cultivating aerobic granular sludge in a developed continuous-flow reactor with two-zone sedimentation tank treating real and low-strength wastewater

Aerobic granulation in a continuous-flow simultaneous nitrification, endogenous denitrification, and phosphorus removal system fed with low-strength wastewater: Granulation mechanism and microbial succession

An Attempt to Develop Aerobic Granular Sludge in Continuous Airlift Reactors

State of the art of aerobic granulation in continuous flow bioreactors

Improving aerobic sludge granulation in sequential batch reactor by natural drying: Effluent sludge recovery and feeding back into reactor

Fast Granulation by Combining External Sludge Conditioning with FeCl3 Addition and Reintroducing into an SBR

Inoculation of aerobic granular sludge to achieve granulation under high dissolved oxygen and the associated mechanisms