Experimental Investigation on Turning of Turbine Blade Material AISI 410 under Minimum Quantity Cutting Fluid

Madan Mohan Reddy Nune,Phaneendra Kiran Chaganti

DOI: https://doi.org/10.1016/j.matpr.2017.01.120

2017-01-01

Materials Today: Proceedings

Abstract:Turbine blade materials are super alloys and they are under go high temperature during machining process between tool and work piece it causes failure of cutting tool and effect the work piece surface roughness. The cutting fluids are used for reducing the effect of temperature in the cutting zone in this context the present paper investigates the turning of turbine blade material AISI 410 with Tungsten carbide tool under the dry, wet and menthol mixed with water cutting conditions. In the dry lubrication the air passes in the cutting zone at room temperature 25°C. In the wet lubrication only waterflows on cutting zone with different temperature say 10°C, 15°C and 25°C. In the third condition small quantity of crystalline menthol powder added to water and used as a cutting fluid. The cutting fluid pressure, velocity maintained constant in all three cutting conditions. A comparison between dry, wet and minimum quantity of menthol is investigated. Finally the results shown that menthol mixed with water act as a better coolant and it concluded that sustainability of machining process has been increased by replacing conventional cutting fluids with developed eco-friendly cutting fluids.