Calibration of medical gamma cameras for estimation of internal contamination from 137 Cs

Martin Hjellström,Mats Isaksson
DOI: https://doi.org/10.1088/1361-6498/ad37c9
2024-03-28
Journal of Radiological Protection
Abstract:Calibration of 22 gamma camera units was performed at 15 hospitals in southern and western Sweden to estimate 137 Cs contamination in humans in a supine static geometry, with a new developed calibration protocol and phantom. The minimum detectable activities (MDAs) and the estimated committed effective doses (CEDs) were calculated for each calibration. Generic calibration factors were calculated for five predetermined groups based on the detector type and manufacturer. Group 1 and 2 included NaI-based gamma cameras from General Electrics (GE) with a crystal thickness of 5/8′′ and 3/8′′ respectively. Group 3 and 4 included NaI-based gamma cameras from Siemens Healthineers with a crystal thickness of 3/8′′, with a similar energy window as the GE NaI-based cameras and a dual window respectively. Group 5 included semiconductor-based gamma cameras from GE with a CdZnTe (CZT) detector. The generic calibration factors were 60.0 cps/kBq, 52.3 cps/kBq, 50.3 cps/kBq, 53.2 cps/kBq and 48.4 cps/kBq for group 1, 2, 3, 4, and 5 respectively. The MDAs ranged between 169–1130 Bq for all groups, with measurement times of 1–10 min, corresponding to a CED of 4.77–77.6 μSv. A dead time analysis was performed for group 1 and suggested a dead time of 3.17 μs for 137 Cs measurements. The dead time analysis showed that a maximum count rate of 232 kcps could be measured in the calibration geometry, corresponding to a CED of 108–263 mSv. It has been shown that semiconductor-based gamma cameras with CZT detectors are feasible for estimating 137 Cs contamination. The generic calibration factors derived in this study can be used for gamma cameras of the same models in other hospitals, for measurements in the same measurement geometry. This will increase the measurement capability for estimating internal 137 Cs contamination in the recovery phase following Radiological or Nuclear (RN) events.
environmental sciences,public, environmental & occupational health,radiology, nuclear medicine & medical imaging,nuclear science & technology
What problem does this paper attempt to address?