Abstract:The MAX phase has attracted much attention due to its unique properties combined with the merits of both metal and ceramic, including the low density, high electrical conductivity and good oxidation resistance, which makes it significant for possible applications in various high temperature or other environments. There is a lot of research work on Ti2AlX (X=C, N). However little research about thermodynamic properties at high pressure is carried out. So we study the structural, mechanical and thermodynamic properties of Ti2AlC and Ti2AlN at various pressures and temperatures. The first-principles calculations based on electronic density-functional theory framework are used to investigate the properties at various pressures. The cut-off energy is 350 eV. Converged results are achieved with 10102 special K-point meshes. The self-consistent convergence of total energy is set to be 5.010-6 eV/atom. According to the calculated structural parameters at various pressures, we can find that the ratios V/V0 (V0 denotes the system volume at 0 GPa) of Ti2AlX are reduced by 20.59% and 18.93%, respectively, so the compressibility of the system is strong. As the internal pressure increases, the curves of V/V0 become gentle. Then we calculate elastic constants at pressures ranging from 0 to 50 GPa in steps of 10 GPa. It is obvious that the Ti2AlX is mechanically stable because all of the elastic constants satisfy the Born stability criteria. The bulk modulus, shear modulus and Young's modulus linearly increase with internal pressure increasing, implying that the pressure can improve the resistance to volume deformation. The ductility and brittleness can be judged according to Pugh's criterion (ratio of bulk modulus to shear modulus B/G), and the brittle nature turns into ductile nature in a pressure range of 40-50 GPa for the Ti2AlX since the value of B/G exceeds 1.75. Finally, we study the thermodynamic properties at various pressures and temperatures based on the quasi-harmonic Debye approximation theory, including the bulk modulus, heat capacity and thermal expansion coefficient. The bulk modulus decreases with temperature increasing but increases with pressure increasing. The heat capacity at constant volume Cv and the heat capacity at constant pressure Cp have the same variation tendency, while Cv obeys the Dulong-Petit limit. It is easy to see that temperature and pressure have opposite influences on heat capacity and the effect of temperature is more significant than that of pressure. The effects of temperature and pressure on linear expansion coefficient mainly occur at low temperature and the effect of pressure is not so considerable when the pressure exceeds 30 GPa. Above all, the effects of temperature and pressure on thermodynamic properties are inverse.

Metallic Aluminum Suboxides with Ultrahigh Electrical Conductivity at High Pressure

Ab Initio Calculation of Structure and Thermodynamic Properties of Zintl Aluminide SrAl2

Novel High-Pressure Phases of Alp from First Principles

Pressure Stabilized Lithium-Aluminum Compounds with Both Superconducting and Superionic Behaviors

First-principles Study of Ni-Al Intermetallic Compounds under Various Temperature and Pressure

The exotically stoichiometric compounds in Al–S system under high pressure

Structural stability and electrical properties of AlB2-type MnB2 under high pressure

Prediction of new thermodynamically stable aluminum oxides

Physical properties and Debye temperature of Al7Cu2Fe alloy under various pressures analyzed by first-principles

Ab Initio Study of Pressure–induced Metallization and Superconductivity in Orthorhombic LiBH2 Phase under Ultra-High Pressure

High-pressure Electrical Conductivity and Elasticity of Iron-Bearing -Alooh

Structural, Mechanical, and Thermodynamic Properties of Ti2AlX (X = C, N) at High Pressure

Superionic silica-water and silica-hydrogen compounds under high pressure

etic and electronic properties of CrO 2 at multimegabar pressures

Ultrahigh‐Pressure Phase Transitions in FeS2 and FeO2: Implications for Super‐Earths' Deep Interior

Theoretical insights into the crystal and fundamental properties of MgAl9Zn compound: First-Principles calculations

Ab-initio Study of Phase Stability, Elastic and Thermodynamic Properties of AlY Alloy under Pressure

Structural prediction of Fe-Mg-O compounds at Super-Earth's pressures

Stability and Anisotropy of (fexni1−x)2o under High Pressure and Implications in Earth’s and Super-Earths’ Core

Structure and motifs of iron oxides from 1 to 3 TPa

Theoretical study of the elastic and thermodynamic properties of Pt$_{3}$Al with the L1$_{2}$ structure under high pressure