Abstract:A wideband multi-polarized square-horn antenna based on an orthogonal mode transducer (OMT) is developed for working in the whole W-band in this paper. The designed antenna is capable of radiating multiple polarization modes as horizontal polarization (HP) and vertical polarization (VP) when as single-port excitation and left-handed circular polarization (LHCP) and right-handed circular polarization (RHCP) when as dual-port excitation, owing to the characteristic of the OMT with the transmitting of orthogonally polarized waves. A CNC-layered fabrication approach is proposed, which means that the antenna prototype integrating with a Boifot-type OMT, turning waveguide, twisting waveguide and phase shifter is divided into three layers along the vertical direction to be fabricated based on computerized numerical control (CNC) technology. In the design, the turning waveguide and twisting waveguide are employed to achieve plane consistency of the antenna branch ports. Furthermore, a phase shifter is designed to compensate the orthogonally polarized waves, which can keep the phase of the orthogonally polarized waves consistent in a wideband frequency range from 75 GHz to 110 GHz. A prototype is fabricated and measured to verify the performance of the proposed multi-polarization antenna, and the measured results agree well with the simulation ones. In the whole W-band, the value of return loss is better than 10 dB of all polarization modes, and the value of AR of the LHCP and RHCP is below 3.5 dB. The maximum gain of the antenna reaches up to 18.8 dBi at 110 GHz. In addition, regarding the layered structure, the possible layered assembly error analysis is discussed, which verifies the feasibility of the layered machining for this antenna.

What problem does this paper attempt to address?

The main problem that this paper attempts to solve is to develop a broadband multi - polarized horn antenna capable of operating across the entire W - band (75 GHz to 110 GHz). Specifically, the paper focuses on the following aspects: 1. **Implementation of multi - polarization function**: The designed antenna needs to be able to support multiple polarization modes, including horizontal polarization (HP), vertical polarization (VP), left - hand circular polarization (LHCP) and right - hand circular polarization (RHCP). These polarization modes can be achieved through single - port excitation or dual - port excitation. 2. **Broadband performance**: The antenna needs to maintain good performance across the entire W - band from 75 GHz to 110 GHz, especially in terms of return loss and axial ratio (AR). The paper mentions that the return loss is better than 10 dB in all polarization modes, and the axial ratio of LHCP and RHCP is lower than 3.5 dB. 3. **Machining and integration**: In order to achieve the multi - polarization function of the antenna, the paper proposes a layered manufacturing method based on computer numerical control (CNC) technology. This method not only solves the problem of multi - port planar consistency that is difficult to achieve in traditional manufacturing methods, but also reduces the influence of assembly errors through the layered structure. 4. **Phase compensation**: Due to the differences in the transmission paths of orthogonal polarized waves, the phase difference will be unstable. For this reason, the paper designs a phase shifter to compensate for these phase differences and ensure that the phases of orthogonal polarized waves are consistent in a wide frequency band. Through the above design and optimization, the paper has successfully developed a high - performance multi - polarized horn antenna that can operate stably across the entire W - band and has good broadband characteristics.

A Whole W-Band Multi-Polarization Horn Antenna Based on Boifot-Type OMT