Abstract:Simulated measurements of traditional shipping container screening infrastructure based on large-area polyvinyl-toluene (PVT) or sodium-iodide detectors (NaI) are used alongside an iterative reconstruction algorithm to characterize the activity and location of a radioactive point source concealed within a shipping container loaded with cargo. A maximum likelihood expectation maximization reconstruction method is employed to reconstruct the source distribution under the assumption that there exists a single point source in the scenario. To account for shielding by the cargo, it is assumed that the encompassing cargo, which was chosen to represent iron cargo, such as scrap metal or machine parts, is homogeneously distributed throughout the 32.2-m 3 container at realistic loaded container densities of 0.0, 0.2, or 0.6 gcm −3 . When the material properties of the cargo are assumed known and provided to the algorithm, the method is capable of localizing the source to within 40.5 cm and estimating the activity to the correct order of magnitude for cases with no cargo and 0.2 gcm −3 iron cargo completely filling the 32.2-m 3 volume. With iron cargo at a density of 0.6 gcm −3 , the localization and activity estimation is significantly worse, which is attributed to the method of accounting for attenuation in the cargo, a decreased signal-to-noise ratio, and the use of gross-count data that include the effect of buildup radiation. Using 662-keV photopeak data from a NaI-based radiation portal monitor (RPM) achieves better results than gross-count data from a PVT- or NaI-based RPM with the correct order of magnitude activity estimates for all cargo densities. For scenarios where the material of the cargo is unknown, but its density and distribution are known, a brute-force search is performed to find the optimum mass attenuation coefficient that describes the cargo. From the range of mass attenuation coefficients obtained, the method is not capable of differentiating between different types of common cargo, but demonstrates the principle of the method for characterizing shipping container cargo. Ultimately, the largest limiting factor in this method is the use of a simple average to estimate the path length traveled from a point in the container through the cargo in the direction of a detector. The large area detectors result in a high variance in this path length, and the degree of attenuation is exponentially dependent on this value. Despite the simple method of accounting for attenuation in the cargo, the maximum likelihood expectation maximization point source (MLEM PS) method is able to characterize a concealed point source well in the case with a PVT-based RPM and 0.2 gcm −3 , which is cargo above the average density of a shipping container, drastically reducing the search area in secondary screening processes. The MLEM PS algorithm, therefore, represents a means of enhancing shipping container screening procedures without requiring significant changes in infrastructure and hardware.

Radioactive source localization using a mobile radiation detection system featuring informed path-based decisions

Neutron and Gamma-Ray Detection System Coupled to a Multirotor for Screening of Shipping Container Cargo

State-of-the-Art Mobile Radiation Detection Systems for Different Scenarios

LOCALIZATION OF RADIATION SOURCES USING RANDOMLY DISTRIBUTED DETECTORS

Detecting, identifying, and localizing radiological material in urban environments using scan statistics

Radioactive Source Localisation via Projective Linear Reconstruction

Radioactive source recognition with moving Compton camera imaging robot using Geant4

Radioactive Source Monitoring System Based on RFID and GPRS

Simulations and Experimental Verifications of an Algorithm for Radiation Source Mapping and Navigational Path Generation

Absolute Gamma Source Positioning with Position-sensitive Scintillation Detector Arrays

Detecting and tracking multiple mobile radioactive sources by data fusion of a surveillance camera and a sodium iodide (NaI) detector

Location and Activity Characterization of Gamma-Ray Point Sources Concealed in Shipping Containers Using Iterative Reconstruction and Modeling Cargo-Specific Attenuation

Robust Localization of an Arbitrary Distribution of Radioactive Sources for Aerial Inspection

Simulated Performance Of Algorithms For The Localization Of Radioactive Sources From A Position Sensitive Radiation Detecting System (COCAE)

Localizing multiple radiation sources actively with a particle filter

Real-Time Gamma Radioactive Source Localization by Data Fusion of 3D-LiDAR Terrain Scan and Radiation Data from Semi-Autonomous UAV Flights

Detection and Localization of Hidden Radioactive Sources with Spatial Statistical Method

Improving Radioactive Material Localization by Leveraging Cyber-Security Model Optimizations

A novel approach to the localization and the estimate of radioactivity in contaminated waste packages via imaging techniques

Hybrid optimization and Bayesian inference techniques for a non-smooth radiation detection problem

Mobile Object Tracking in Panoramic Video and LiDAR for Radiological Source-Object Attribution and Improved Source Detection