Impact of air‐polishing with erythritol on exposed root dentin: A randomized clinical trial

Anne Brigitte Kruse,Ann‐Sophie Burkhardt,Kirstin Vach,Elmar Hellwig,Johan Peter Woelber,Nadine Schlueter,Petra Ratka‐Krüger
DOI: https://doi.org/10.1111/idh.12835
2024-06-11
International Journal of Dental Hygiene
Abstract:Introduction The effects of air‐polishing on exposed root dentin surfaces are largely unknown, as there are only few studies which show heterogeneous results. Thus, this study was to investigate roughness changes of exposed dentin surfaces after air‐polishing and the influence of subsequent polishing with cup and paste. Methods Totally 54 teeth with exposed root dentin surfaces were treated using a split‐mouth design by either air‐polishing with erythritol and a rubber cup with polishing paste on the test side, or rubber cup and paste alone. Teeth were finally cleaned using a sonic tooth brush. Impressions were taken at relevant time points and replicated using epoxy resin. The resulting casts were profilometrically analysed to obtain the average surface roughness (sRa) and maximum peak‐to‐valley height (sRz), which are given as the mean ± standard deviation in μm. Results After air‐polishing, in comparison to the baseline, there was a slight but significant increase in sRa (0.168 ± 0.143, p
dentistry, oral surgery & medicine
What problem does this paper attempt to address?