Sustainable binary/ternary blended mortars with recycled water treatment sludge using fly ash or blast slag: Characterization and environmental-economical impacts

Ceren Kina

DOI: https://doi.org/10.1007/s11356-024-32175-7

IF: 5.8

2024-01-30

Environmental Science and Pollution Research

Abstract:Abstract Water treatment sludge (WTS) is produced daily and disposed of as hazardous material. It would be advisable to use locally available waste products as supplementary cementitious materials that ensure to be disposed of without harming the environment. As a novelty, this research investigated the potential of using recycled WTS with fly ash (FA) and ground-granulated blast furnace slag (BFS) as ternary blended binders. Thus, it can provide an economical solution and alleviate the adverse environmental effects of excessive production of wastes and cement production. Within this scope, the mortars with 0–30 wt% replacement of cement with modified WTS (MWTS) were produced as binary blend, and also, they were combined with FA/BFS as ternary blended binders. Therefore, optimum utilization of waste products into the mortar in terms of rheological, mechanical, durability, microstructural properties, and environmental-economical aspects was examined. Adding 10% recycled WTS as binary caused higher strengths with lower porosity measured by the mercury intrusion porosimeter test and denser microstructure, as revealed by XRD patterns and SEM results. However, the drawbacks of using recycled WTS, in terms of rheological parameters and environmental-economical aspects, were suppressed by adding FA/BFS with comparable strength values. Specifically, cost, CO 2 footprint, and embodied energy were reduced by combining 10% MWTS with FA by 8.87%, 37.88%, and 33.07%, respectively, while 90-day compressive and flexural strength were 5.1% and 5.32% lower. This study developed a feasible solution to use recycled MWTS by obtaining more eco-friendly and cost-effective cement-based materials. Graphical Abstract

environmental sciences

What problem does this paper attempt to address?

The main problem that this paper attempts to solve is to explore how to reduce the negative environmental impacts of cement production and waste disposal and provide economically viable solutions by using recycled water treatment sludge (WTS) with fly ash (FA) or blast furnace slag (BFS) as binary or ternary blended cementitious materials. Specifically, the research aims to evaluate the performance of these blended materials in terms of rheology, mechanical properties, durability, microstructure characteristics, and environmental - economic impacts, with a view to developing more environmentally - friendly and cost - effective cement - based materials.

The paper mentions that water treatment sludge is a hazardous waste generated daily. If it can be used as a supplementary cementitious material, it can not only reduce its harm to the environment but also reduce carbon emissions and energy consumption in the cement production process. However, the direct use of untreated WTS poses some challenges, such as poor rheological parameters and environmental - economic impacts. Therefore, this study specifically focuses on the effect of using high - temperature - calcined modified WTS (MWTS) in combination with FA or BFS to overcome these problems.

The research results show that adding 10% MWTS can increase the strength of mortar, reduce porosity, and form a denser microstructure. However, using MWTS alone will bring disadvantages such as a decline in rheological properties, and these disadvantages can be alleviated by combining it with FA or BFS. In particular, when 10% MWTS is used in combination with FA, although the compressive and flexural strengths at 90 days are reduced by 5.1% and 5.32% respectively, the cost, carbon dioxide footprint, and embodied energy are reduced by 8.87%, 37.88%, and 33.07% respectively. This indicates that more environmentally - friendly and economic preparation of cement - based materials can be achieved through reasonable design of the mixing ratio.