A Giemsa Stain of Quite Constant Composition and Performance, made in the Laboratory from Eosin and Méthylène Blue.

R. Lillie

DOI: https://doi.org/10.2307/4584400

Abstract:When the eosinate formula (1) for compounding Giemsa stain from dyes of American manufacture was worked out, it was hoped that this would solve the problem of duplicating stains satisfactorily. However, continued experience with successive commercial lots from several American mnanufacturers indicated that commercial azure A, azure B, and azure I were quite variable substances and that considerable study and adjustment of proportions was necessary each time a new lot of Giemsa stain was offered. On spectroscopic examination of various lots of the azures and methylene blue anid their eosinates, the reason for this variability became apparent, as may be seen from table 1. Considering the relative constancy of the spectroscopic data for methylene blue chloride, it seems that the variation in the azures is probably inherent in their mode of nmanufacture from methylene blue. If the traditional method of chloroform extraction of the base from weakly alkaline aqueous solution of polychrome methylene blue is employed, the composition of the product will depend to some extenit on that of the polychrome methylene blue from which it is prepared. Not only azure I or B and methylene violet appear in the chloroform extract, but also, though in less amounts, azure A and azure C, and the three azures are all reextracted from chloroform solution by weak acetic acid. Consequently, if methiylene blue polychromed by an alkali process is employed as a source of azures, a mixed product will be obtained, since alkali polychroming engenders simultaneously a wide variety of the decomposition products of methylene blue. The method of formaldebyde remethylation of crude azure A made by the acid oxidation process does not stop at trimethylthionin as was supposed, but may go on to methylene blue. Experimental extraction of some commercial azure B solutions with chloroform until no more red color was produced in the chloroform has left a deep blue solution with the spectral characteristics of methylene blue and as much as 20 to 25 percent of the color density of the original solution. Having shown that the acid oxidation process (2) produced polychrome methylene blues of quite constant spectroscopic characteristics when the same ratio of K,Cr207 to methylene blue was used, and that after a certain time interval varying with temperature, further heating was without effect, and that the same product was produced at varying temperatures, it was believed that this process might prof-

Chemistry,Medicine