Abstract:Ambitious electrification roadmaps for the automotive industry have prompted a revolution in winding technology for traction motors in electric vehicles (EV). Hairpin windings with reduced power losses and improved coolability are overtaking the market compared with stranded windings. Currently, most hairpin winding solutions use state-of-the-art end winding cooling strategies. This, however, still cannot bridge the gap for high performance requirements, so supplementary in-slot cooling is needed to make the next step change in achieving high power density. This paper will investigate direct in-slot cooling of hairpin windings with a focus on cooling channel arrangement. A novel analytical parametric Lumped Parameter Thermal Network modelling methodology is developed to choose the thermally optimal in-slot cooling channel radial position for a 150kW high speed traction motor. Two operating points (corner and peak speed) on the peak torque-speed curve are studied to investigate how machine losses influence the choice of the optimal cooling channel position. Changing loss distributions showed an optimal middle channel position for the corner speed and shift towards the airgap at peak speed. A typical slot-opening channel position was shown to reduce hotspot temperatures by 23 K compared with a no-in-slot cooling benchmark, for the most thermally challenging operating point. A further 8 K reduction is achieved, compared to the benchmark, for the most thermally challenging operating condition, when a central cooling channel position is chosen. The novelty of this paper is the multiphysics electromagnetic and thermal modelling methodology integration which the trade-off between losses and temperatures, as impacted by a changing channel position, capture. An FEA model was built to validate the LPTN results for the benchmark case; the temperature rise between the hotspot slot peak and the oil inlet temperature, was predicted within 5%.

Windings Indirect Liquid Cooling Method for a Compact Outer-Rotor PM Starter/Generator With Concentrated Windings

Enhanced Ventilation and Thermal Performance by Skewed Through Holes on Rotor Yoke in Forced Air-Cooled Permanent Magnet Wind Generators

Optimization Design of a Permanent Magnet Synchronous Generator for a Potential Energy Recovery System

Design and analysis of a novel hybrid cooling method of high-speed high-power permanent magnet assisted synchronous reluctance starter/generator in aviation applications

A Novel Cooling Technique for the Windings of High-Torque-Density Permanent Magnet Machines

Design Of A Dual-Stator Superconducting Permanent Magnet Wind Power Generator With Different Rotor Configuration

Cooling System Analysis of an Enclosed Yokeless Stator for High-Power Axial Flux PM Motor with Distributed Winding

Water Cold Plates for Efficient Cooling: Verified on a Permanent-Magnet Machine with Concentrated Winding

Thermal Analysis and Cooling System Design of Dual Mechanical Port Machine for Wind Power Application

Ventilation and Thermal Improvement of Radial Forced Air-Cooled FSCW Permanent Magnet Synchronous Wind Generators

Loss and Thermal Analysis of a High-Power-Density Permanent Magnet Starter/Generator

Design of a Compact Axial Flux Permanent Magnet Machine for Hybrid Electric Vehicle

Permanent-Magnet Flux-Switching Integrated Starter Generator with Different Rotor Configurations for Cogging Torque and Torque Ripple Mitigations

Design and optimisation of oil injection pipe cooling structure for permanent magnet synchronous motors in hybrid electric vehicles

Inner Evaporative Cooling Wind Power Generator With Non-Overlapping Concentrated Windings

Comparative Investigation and Optimization of a Direct Cooling Structure for the Primary Core and Windings in Permanent Magnet Synchronous Linear Motors

Temperature Field Analysis and Cooling Structure Optimization for Integrated Permanent Magnet In-Wheel Motor Based on Electromagnetic-Thermal Coupling

In-Slot Oil Cooling Arrangement of Hairpin Windings for High Power Density EV Traction Motors

Coupled Fluid-Solid Heat Transfer of A Gas and Liquid Cooling PMSM Including Rotor Rotation

Application and Verification of Spiral Water Cooling for Rotor in High-Power Density Motors

Thermal Management Integrated with Flat Heat Pipes for In-Slot Stator Windings of Electric Motors