Abstract:All-carbon flexible supercapacitors are highly promising in powering up wearable electronics in smart textiles. However, their low energy density hinders their practical application due to the lack of an effective fabrication method of highly conductive fiber electrodes with high specific capacitance. Herein, we develop a sustainable, scalable, and cost-effective method to fabricate lignin-based carbon/graphene fiber (GF) hybrid electrodes with a hierarchically porous structure. This engineered structure is achieved by coaxially wet spinning a graphene oxide fiber (GOF) as a core structural support and 0–10% lignin/graphene oxide (GO) as a surface layer, followed by carbonization and KOH activation processes. The obtained fiber electrodes exhibit the highest specific capacitance of 260.48 mF cm–2 at a current density of 0.1 mA cm–2, which is 11 times that of the neat GF from conventional wet spinning. The entire-device energy density of the assembled fiber-based flexible supercapacitors from the optimal fiber electrode is 5.79 μW h cm–2 in a H2SO4/poly(vinyl alcohol) electrolyte. Furthermore, the fiber-based flexible supercapacitors show ultralong cycling life and cycling stability (the capacitance retention rate is 98% after 7000 cycles of charge/discharge at a current density of 0.1 mA cm–2). This work enables the high-value utilization of low-cost carbon precursors (lignin and GO) in potential applications such as energy storage devices for smart textiles.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsaem.1c01379.Polarized optical microscopy image of GO solution at 15 mg mL–1; SEM images of the neat GF and unactivated 5% ; FTIR images of the GOF and GF; CV and GCD curves of the GF, unactivated 5% recorded at 5 mV s–1 and 0.1 mA cm–2; CV and GCD curves of flexible supercapacitors tested in a 2-electrode cell in 1 M H2SO4/PVA electrolyte of 0–10% ; electrical conductivity of ; calculated CA, CV, Esingle,A, and Psingle,A values of fiber electrodes based on GCD curves at a current density of 0.1 mA cm–2; calculated CA of fiber electrodes at different scan rates based on CV measurements; and calculated CA of fiber electrodes at current densities based on GCD measurements (PDF)This article has not yet been cited by other publications.

Direct laser writing of pure lignin on carbon cloth for highly flexible supercapacitors with enhanced areal capacitance

All-solid-state Supercapacitors from Natural Lignin-Based Composite Film by Laser Direct Writing

Enhancing electrochemical performance of carbon fiber with lignin for flexible supercapacitors in PVA/H3PO4 matrix

ZnO-assisted synthesis of lignin-based ultra-fine microporous carbon nanofibers for supercapacitors

Transforming lignin into porous graphene via direct laser writing for solid-state supercapacitors

A facile synthesis of hierarchical porous carbon derived from renewable lignin for high-performance supercapacitor

Lignin-induced rapid-synthesis of deep eutectic solvent-based gel with high robustness and conductivity applied for flexible quasi-solid-state supercapacitors

Fabrication of Graphitized Carbon Fibers from Fusible Lignin and Their Application in Supercapacitors

The synthesis of porous carbons from a lignin-rich residue for high-performance supercapacitors

Conductive Writing with High Precision by Laser‐Induced Point‐to‐Line Carbonization Strategy for Flexible Supercapacitors (Advanced Optical Materials 24/2021)

Free-standing and mechanically flexible mats consisting of electrospun carbon nanofibers made from a natural product of alkali lignin as binder-free electrodes for high-performance supercapacitors

Heteroatom-doped and graphitization-enhanced lignin-derived hierarchically porous carbon via facile assembly of lignin-Fe coordination for high-voltage symmetric supercapacitors

Electrochemical Performance of Coaxially Wet-Spun Hierarchically Porous Lignin-Based Carbon/Graphene Fiber Electrodes for Flexible Supercapacitors

Electrospun flexible lignin/polyacrylonitrile-based carbon nanofiber and its application in electrode materials for supercapacitors

Simple Mixed-Acid-Treated Carbon Fiber Electrodes with Oxygen-Containing Functional Groups for Flexible Supercapacitors

Preparation of spherical porous carbon from lignin-derived phenolic resin and its application in supercapacitor electrodes

Bidirectional pore-creating strategy towards lignin-based heteroatom-doped porous carbon for supercapacitors

Direct Carbonization of Sodium Lignosulfonate Through Self-Template Strategies for the Synthesis of Porous Carbons Toward Supercapacitor Applications

The Design of Binder-Free Self-Supporting Carbon Paper Electrode Based on Biomass Derived Hierarchical Porous Carbon/cellulose Nanofibers for Sustainable Flexible Supercapacitors

Controllable synthesis of Fe 3 C-reinforced petal-like lignin microspheres with boosted electrochemical performance and its application in high performance supercapacitors

Design of a high performance electrode composed of porous nickel–cobalt layered double hydroxide nanosheets supported on vertical graphene fibers for flexible supercapacitors