Abstract:Environmental sanitation in food manufacturing plants promotes food safety and product microbial quality. However, the development of experimental models remains a challenge due to the complex nature of commercial cleaning processes, which include spraying water and sanitizer on equipment and structural surfaces within manufacturing space. Although simple in execution, the physical driving forces are difficult to simulate in a controlled laboratory environment. Here, we present a bench-scale bioreactor system which mimics the flow conditions in environmental sanitation programs. We applied computational fluid dynamic (CFD) simulations to obtain fluid flow parameters that better approximate and predict industrial outcomes. According to the CFD model, the local wall shear stress achieved on the target surface ranged from 0.015 to 5.00 Pa. Sanitation efficacy on six types of environmental surface materials (hydrophobicity, 57.59 to 88.61°; roughness, 2.2 to 11.9 μm) against two different microbial targets, the bacterial pathogen Listeria monocytogenes and Exophiala species spoilage fungi, were evaluated using the bench-scale bioreactor system. The relative reduction ranged from 0.0 to 0.82 for Exophiala spp., which corresponded to a 0.0 to 2.21 log CFU/coupon reduction, and the relative reduction ranged from 0.0 to 0.93 in L. monocytogenes which corresponded to a 0.0 to 6.19 log CFU/coupon reduction. Although most treatment parameters were considered statistically significant against either L. monocytogenes or Exophiala spp., contact time was ranked as the most important predictor for L. monocytogenes reduction. Shear stress contributed the most to Exophiala spp. removal on stainless steel and Buna-N rubber, while contact time was the most important factor on HDPE (high-density polyethylene), cement, and epoxy.IMPORTANCE Commercial food manufacturers commonly employ a single sanitation program that addresses both bacterial pathogen and fungal spoilage microbiota, despite the fact that the two microbial targets respond differently to various environmental sanitation conditions. Comparison of outcome-based clusters of treatment combinations may facilitate the development of compensatory sanitation regimes where longer contact time or greater force are applied so that lower sanitizer concentrations can be used. Determination of microbiological outcomes related to sanitation program efficacy against a panel of treatment conditions allows food processors to balance tradeoffs between quality and safety with cost and waste stream management, as appropriate for their facility.

Equipment Cleaning, Sanitation, and Maintenance

Dry Cleaning, Wet Cleaning, and Alternatives to Processing Plant Hygiene and Sanitation

Design and Performance of Systems for Cleaning Product-Contact Surfaces of Food Equipment: A Review

Hygienic factory design for food processing

Guidelines for food safety, health operations and production

All Treatment Parameters Affect Environmental Surface Sanitation Efficacy, but Their Relative Importance Depends on the Microbial Target

Integration of Hazard Analysis and Critical Control Points HACCP with Maintenance Practices: Enhancing Food Safety in the Food and Beverage Industry; A Review.

Food Microbial Hazards, Safety, and Quality Control

The hazard analysis and critical control point system in food safety

Determination of the Critical Control Points of Microbial Contamination in the Production and Distribution of Hospital Food

HACCP, quality, and food safety management in food and agricultural systems

Development and trend of dairy cleaning agents

Cleaning,sterilization and management of surgical devices in hospital sterilization and supply center

On The Technical Process Of Safety Before The Maintenance Of Chemical Equipments

Control of the aseptic processing environment

Microbiological environmental sampling, records and record interpretation

Brief Introduction of Food Processing Methods and Chemical Hazards Formed during Thermal Processing

Food Hygiene Problems and Management Measures of the Culinary Training Room

Challenges in Cleaning: Recent Developments and Future Prospects

Advancements in Food Safety and Quality Control in Food Processing and Manufacturing

Mechanical Properties Improvements of the Materials Used in Manufacturing of Food Processing Equipment’s and Containers Using Different Techniques