Abstract:The effect of nonspherical (i.e. cylindrical) bomb geometry on the evolution Of Outwardly propagating flames and the determination of laminar flame speeds using the conventional constant-pressure technique is investigated experimentally and theoretically. The cylindrical chamber boundary modifies the propagation rate through the interaction of the wall with the flow induced by thermal expansion across the flame (even with constant pressure), which leads to significant distortion of the flame surface for large flame radii. These departures from the unconfined case, especially the resulting nonzero burned gas velocities, can lead to significant errors in flame speeds calculated using the conventional assumptions, especially for large flame radii. For example, at a flame radius of 0.5 times the wall radius, the flame speed Calculated neglecting confinement: effects can be low by similar to 15% (even with constant pressure). A methodology to estimate the effect of nonzero burned gas velocities on the measured flame speed in cylindrical chambers is presented. Modeling and experiments indicate that the effect of confinement can be neglected for flame radii less than 0.3 times the wall radius while still achieving acceptable accuracy (within 3%). The methodology is applied to correct the flame speed for nonzero burned gas speeds, in order to extend the range of flame radii useful for flame speed measurements. Under the proposed scaling, the burned gas speed can be well approximated as a function of only flame radius for a given chamber geometry - i.e. the correction function need only be determined once for an apparatus and then it can be used for any mixture. Results indicate that the flow correction can be used to extract flame speeds for flame radii tip to 0.5 times the wall radius with somewhat larger, yet still acceptable uncertainties for the cases Studied. Flow-corrected burning velocities are measured for hydrogen and syngas mixtures at atmospheric and elevated pressures. Flow-corrected flame speeds in the small cylindrical chamber used here agree well with previously reported flame speeds from large spherical chambers. Previous papers presenting burning velocities from cylindrical chambers report performing data analysis on flame radii less than 0.5 or 0.6 times the wall radius, where the flame speed calculated neglecting confinement effects may be low by similar to 15 or 20%, respectively. For cylindrical chambers, data analysis should be restricted to flame radii less than 0.3 times the wall radius or a flow correction should be employed to account for the burned gas motions. With regard to the design of future vessels, larger vessels that minimize the flow aberrations for the same flame radius are preferred. Larger vessels maximize the relatively unaffected region of data allowing for a more straightforward approach to interpret the experimental data. (c) 2009 The Combustion Institute. Published by Elsevier Inc. All rights reserved.

A Novel Approach for Accurate Determination of Laminar Burning Velocity Using the Constant Volume Method in a Cylindrical Vessel with Full Optical Access

The Laminar Burning Velocities of Stoichiometric Methane–Air Mixture from Closed Vessels Measurements

Local Flame And Flow Properties Of Propagating Premixed Turbulent Flames During Light-Round Process In A Micca-Type Annular Combustor

Effect of Cylindrical Confinement on the Determination of Laminar Flame Speeds Using Outwardly Propagating Flames

The Constant-Volume Propagating Spherical Flame Method for Laminar Flame Speed Measurement

Determination of Burning Velocities from Spherically Expanding H 2 /air Flames

Development of an Optically Accessible Apparatus to Characterize the Evolution of Spherically Expanding Flames under Constant Volume Conditions

A study of propagation of spherically expanding flames at low pressure using direct measurements and numerical simulations

Measurement and scaling of turbulent burning velocity of ammonia/methane/air propagating spherical flames at elevated pressure

Investigating the Laminar Burning Velocity of NH3/H2/air Using the Constant Volume Method: Experimental and Numerical Analysis

Laminar burning velocity of Ammonia/Air mixtures at high pressures

Investigation of Flame and Burner Plate Interaction During the Heat Flux Method Used for Laminar Burning Velocity Measurement

Laminar Burning Velocities of Hydrogen-Blended Methane–Air and Natural Gas–Air Mixtures, Calculated from the Early Stage of p(t) Records in a Spherical Vessel

Investigating the Laminar Burning Velocity of 2-Methylfuran

Experimental and numerical investigations of the laminar burning velocities of premixed fuel-rich methane oxy-fuel and oxygen-enhanced flames

Numerical Investigation of a High Momentum Jet Flame at Elevated Pressure: A Quantitative Validation with Detailed Experimental Data

Research of Measure and Control System for Laminar Burning Velocity in Constant Volume Combustion Chamber

Experimental and Numerical Study of the Laminar Burning Velocity of Biogas–Ammonia–Air Premixed Flames

The effect of finite molecular volume on the propagation of unsteady spherical flame front

Intermittent flame lengths of buoyant jet flames in reduced and normal pressures: Experiments and theoretical analysis

A Compilation of Experimental Data on Laminar Burning Velocities