Abstract:Two-compartment electrodialytic extraction (2C-ED) is a one-step process for the simultaneous phosphorous extraction and separation of heavy metals from sewage sludge ash (SSA). The process is driven by an applied electric DC field, which can be supplied from renewable sources. The proof-of-concept of the method was conducted in small laboratory cells; however, upscaling to a continuous 2C-ED process, which additionally can treat SSA suspensions at a low liquid-to-solid (L:S) ratio, requires a new design. This paper presents such a new design. In principle, ED consists of two compartments separated by a cation exchange membrane. One compartment contains a suspension of SSA in water and the anode. A cathode is placed in the other compartment. Electrolysis at the anode acidifies the suspension causing the dissolution of phosphorous and heavy metals. The heavy metals are separated from the suspension by electromigration into the catholyte, whereas the dissolved phosphorous remains in the dispersion solution. In the new design, the SSA was suspended in a tube-shaped reactor with the cation exchange membrane covering the outside. The reactor was placed in a container with the catholyte. Periodically turning off the reactor kept SSA in suspension even at a low L:S ratio without corners and pockets where the SSA otherwise tends to settle. Five 2C-ED experiments were conducted with 1.5 to 3 kg SSA at varying currents and durations. Up to 89% P was extracted. The extracted P was concentrated in the dispersion solution of the SSA suspension, where the obtained P-related concentrations of heavy metals were far below the limiting values for spreading on agricultural land. The experiments underlined that treating the SSA in a suspension with a low L:S ratio is advantageous. A comparison to previous laboratory experiments in small cells treating 50 g SSA shows a significantly more efficient use of the applied current in the new reactor setup. Thus, the new reactor design for 2C-ED fulfilled the set criteria for the operation and did additionally result in a higher efficiency than the laboratory setups, i.e., the design can be the first step towards an upscaling.

Extraction of phosphorus from sewage sludge ash by electrodialysis combined with wet-chemical extraction

Simultaneous P Release and Recovery from Fish Farm Sludge Using a Zr-modified Magnetic Adsorbent Treated by Ultrasound

On wet chemical phosphorus recovery from sewage sludge ash by acidic or alkaline leaching and an optimized combination of both

Phosphorous extraction and heavy metal separation from sewage sludge ash by two-compartment electrodialysis in an upscaled tube reactor

Electrokinetic Gathering and Removal of Heavy Metals from Sewage Sludge by Ethylenediamine Chelation

A comparison between sulfuric acid and oxalic acid leaching with subsequent purification and precipitation for phosphorus recovery from sewage sludge incineration ash

Optimization of phosphorus wet acid extraction from sewage sludge ashes: Detailed process insight via multi-variate statistical techniques

Synergistic application of alum sludge and sequential extraction for phosphorus recovery from sewage sludge char

Feasibility of wet-extraction of phosphorus from incinerated sewage sludge ash (ISSA) for phosphate fertilizer production: A critical review

Sequential wet extraction of phosphorus from sewage sludge using alum sludge: Reassessing the aluminium-phosphorus speciation using experimental and simulation approach

Hydrothermally Stimulated Molecular Interfaces for Augmented Electron Delocalization in Wet-Chemical Phosphorus Recovery from Incineration Ash of Sewage Sludge

Remove and Recover Phosphorus During Anaerobic Digestion of Excess Sludge by Adding Waste Iron Scrap

Efficient phosphorus recycling and heavy metal removal from wastewater sludge by a novel hydrothermal humification-technique

Efficient extraction of phosphorus from food waste biogas digestate ash through two-compartment electrodialysis cell

Alkaline modification of the acid residue of incinerated sewage sludge ash after phosphorus recovery for heavy metal removal from aqueous solutions

Phosphorus recovery from hydrothermal conversion products of sewage sludge through wet-chemical methods

Assessment of a simple and replicable procedure for selective phosphorus recovery from sewage sludge ashes by wet chemical extraction and precipitation

Characteristic of wet method of phosphorus recovery from polish sewage sludge ash with nitric acid

Efficient and Selective Recovery of Iron Phosphate from the Leachate of Incinerated Sewage Sludge Ash by Thermally Induced Precipitation

Calcium oxide-enhanced phosphorus recycling using sewage sludge degradative solvent extraction technology

Aluminium sulfate synergistic electrokinetic separation of soluble components from phosphorus slag and simultaneous stabilization of fluoride