Abstract:The physics of combusting flows consists of a complex interaction between chemical reactions, fluid mechanics and radiation. Temperature is one of the most important parameters for the processes. Laser-based imaging techniques are frequently used to assess temperature information from reactive systems without perturbing the system under study. To verify the feasibility of the temperature measurement of UV tunable absorption spectroscopy technology the methane/air premix flat flame was selected as the target of test because of the combustion stability of this kind of flame. Before the temperature measurement the distribution of OH radical in the premix flat flame under different operating conditions were obtained by using planar laser induced fluorescence (PLIF). At the low equivalence ratio the OH radicals distribute uniformly in the flame for the adequate oxygen in the premix gas. The condition with uniform distribution of OH in the flame was selected for the UV tunable absorption spectroscopy measurement. For the selection of absorption lines of the measurement the spectrum of OH A-X(0,0) band have been simulated by LIFBASE. Considering the slope sensitivity and SNR of the test the transitions P1(2) and Q1(8) were suitable for the temperature measurement of the flame. A dye laser pumped by a frequency doubled Nd:YAG laser was used to generated the UV laser. The dye laser was operated with the mixed dye of DCM and PM580 for high conversion efficiency at 310 nm. To investigate the transitions of Q1(8) and P1(2) of OH A-X(0,0) the laser was tuned from 309.225~309.255 and 308.625~308.655 nm separately with the step of 0.4 pm, 30 pulses were recorded at each step. The laser pulses reflected by the beam splitter were collected by detector A, and the pulses passed the flame were collected by detector B. The signal of these two detectors were recorded by the oscilloscope and acquired by the computer automatically. The line shape of these transitions can be obtained after fitting the experimental data with the Voigt function. The integral ratio between the fitting results of these two lines was calculated. Then temperature of the flame could be deduced by the integral ratio. The temperatures of different positions above the surface of burner and varied heights of the flame center were obtained by measuring the integrated absorption ratio of these two transitions. The test results of this method are compared with the report in reference, in which temperature of the burner with the same structure was measured by other ways. The results of these two tests agree well. It shows that this method has the potential to be a calibration for the two-dimension thermometry in flame such as two-line PLIF.

One-dimensional equivalence ratio measurements by femtosecond laser filament-triggered discharge plasma spectroscopy

Equivalence Ratio Measurements in CH4/Air Gases Based on the Spatial Distribution of the Emission Intensity of Femtosecond Laser-Induced Filament

The Flame Length Measurements of Oxygen-Enriched Carbon Dioxide-Diluted Methane Inverse Diffusion Flames

One-dimensional temperature measurement of gases based on femtosecond laser-extended electrode discharge spectroscopy (FEEDS)

Quantitative acetone/toluene planar laser‐induced fluorescence measurements of equivalent ratio

Simultaneous In-Situ Measurement of Soot Volume Fraction, H2O Concentration, and Temperature in an Ethylene/Air Premixed Flame Using Tunable Diode Laser Absorption Spectroscopy

Temperature and Thermal Diffusivity Diagnostics in Laminar Methane Flames Using Infrared Four-Wave Mixing Techniques

Fire Extinguishing Performance Evaluation of the Downward Water Mist to Methane-Air Premixed Laminar Flame

Studies On Gas Concentration Reconstruction Methods For Simultaneous Temperature And H2o Concentration Tomographic Imaging In A Flame Based On Tunable Diode Laser Absorption Spectroscopy

Temperature Measurement in Combustion Flow Field with Femtosecond Laser-Induced Filament

Simultaneous High-Speed SO2 PLIF Imaging and Stereo-Piv Measurements in Premixed Swirling Flame at 20 Khz.

Quantitative measurement of hydroxyl radical (OH) concentration in premixed flat flame by combining laser-induced fluorescence and direct absorption spectroscopy

PLIF measurements of instantaneous flame structures and curvature of an acoustically excited turbulent premixed flame

Multiparameter Measurement in Ethylene Diffusion Flame Based on Time-Division Multiplexed Tunable Diode Laser Absorption Spectroscopy

Development of Equivalence Ratio Measurement Model of Premixed Methane Flames Using Hyperspectral Imaging of C2* and CH* Chemiluminescence and Random Forest Algorithm

Effects of Gas Temperature on Equivalence Ratio Measurement in Premixed Methane–air Flame Using Laser-Induced Breakdown Spectroscopy

Femtosecond Laser Filamentation for Sensing Combustion Intermediates: A Comparative Study

Simultaneous Measurement of 2-Dimensional H2O Concentration and Temperature Distribution in Premixed Methane/air Flame Using TDLAS-based Tomography Technology

[Temperature Measurement of CH4/Air Premix Flat Flame Based on the Absorption Spectroscopy Technology of UV Tunable Laser]

Plasma-assisted NH 3 /air flame: Simultaneous LIF measurements of O and OH

Experimental investigations of equivalence ratio effect on nonlinear dynamics features in premixed swirl-stabilized combustor