Abstract:Biomass is a unique renewable carbon resource that can be flexibly converted into biofuels, chemicals, and biomaterials using pyrolysis technology. Microwave-assisted pyrolysis (MAP) has gained increasing attention due to its faster and more uniform heating characteristics compared to conventional pyrolysis (CP). However, thermodynamic assessments of biomass MAP-based systems that consider detailed pyrolytic product information are lacking. This study simulated biomass-derived poly-generation systems employing MAP with microwave absorbers (MAP-S) and CP with solid heat carriers (CP-S). The proposed systems included pretreatment, pyrolysis, bio-oil rectification, hydrodeoxygenation, and combined cycle power units, producing biofuels, chemicals, and electricity. To obtain operating information that aligns more closely with engineering reality, pilot-scale numerical models integrating reaction kinetics and transport processes were established for the MAP and CP reactors. These models were validated against lab-scale experimental results after scaling down the models' geometrical sizes. The results of product yields and energy consumption from numerical simulations were used to support the process simulation. Simulation results showed that the energy efficiency and net power generation efficiency of MAP-S were 59.37 % and 17.78 %, respectively, lower than the 67.19 % and 18.22 % of CP-S. In CP-S, the exergy of materials primarily moved towards the chemicals production units with an exergy efficiency ( η ex ) of 60.0 %, whereas in MAP-S, more exergy flowed towards the power generation units with a lower η ex of 58.46 %. Notably, the exergy destruction rate ( Ex d ) for CP-S was 3.91 MW, higher than the 3.65 MW for MAP-S. Moreover, the CP-S achieves a higher carbon utilization efficiency at 42.32 %, compared to 35.03 % for the MAP-S. For the pyrolysis units, although the CP unit experienced higher heat losses (0.31 MW) compared to the MAP unit (0.1 MW), the η ex for the CP unit was higher due to a lower Ex d . Additionally, CP-S consumed more hydrogen in the hydrodeoxygenation units, whereas MAP-S might achieve self-supply of hydrogen by adjusting operation conditions and technology processes.

Processes simulation and environmental evaluation of biofuel production via Co-pyrolysis of tropical agricultural waste

Process Simulation, Thermodynamic and System Optimization for the Low-Carbon Alcohols Production Via Gasification of Second-Generation Biomass

Study on Co-Pyrolysis of Coal and Biomass and Process Simulation Optimization

Numerical Simulation and Multi-Process Coupling Analysis for Biomass Pyrolysis Fluidized Bed Reactor Based on Synergistic Effects Between Biomass and Nitrogen Inlet Modes

Process Simulation of Preparing Biochar by Biomass Pyrolysis Via Aspen Plus and Its Economic Evaluation

Conversion of oil palm waste into value-added products through pyrolysis: a sensitivity and techno-economic investigation

Co-pyrolysis of biomass/polyurethane foam waste: Thermodynamic study using Aspen Plus

Sustainable design and optimization of co-processing of bio-oil and vacuum gas oil in an existing refinery

Process simulation and economic and environmental evaluation of a corncob-based biorefinery system

Upgradation of agricultural straw pyrolysis through co-processing with PE waste and by-product detoxification

Simulation analysis of Co-Pyrolysis of oil shale and wheat straw based on the combination of chain reaction kinetics and improved CPD models

Co-pyrolysis re-use of sludge and biomass waste: Development, kinetics, synergistic mechanism and industrialization

Simulation and optimization of co-pyrolysis biochar using data enhanced interpretable machine learning and particle swarm algorithm

Effective waste management through Co-pyrolysis of EFB and tire waste: Mechanistic and synergism analysis

Catalytic Pyrolysis of Biomass and Polymer Wastes

Kinetics Study on Biomass Pyrolysis for Fuel Gas Production

Simulation of a Continuous Pyrolysis Reactor for a Heat Self-Sufficient Process and Liquid Fuel Production

Improved simulation of lignocellulosic biomass pyrolysis plant using chemical kinetics in Aspen Plus® and comparison with experiments

A review on co-pyrolysis of agriculture biomass and disposable medical face mask waste for green fuel production: recent advances and thermo-kinetic models

Enhanced biofuel production by co-pyrolysis of distiller's grains and waste plastics: A quantitative appraisal of kinetic behaviors and product characteristics

A comparative thermodynamic assessment of microwave-assisted and conventional pyrolysis of biomass in poly-generation systems using coupled numerical and process simulations