Abstract:The microstructural, electrical, and optical properties of Cu-doped and undoped ZnTe thin films grown on glass substrates are covered in this article. To determine the chemical makeup of these materials, both energy-dispersive X-ray (EDAX) spectroscopy and X-ray photoelectron spectroscopy were employed. The cubic zinc-blende crystal structure of ZnTe and Cu-doped ZnTe films was discovered using X-ray diffraction crystallography. According to these microstructural studies, the average crystallite size increased as the amount of Cu doping increased, whereas the microstrain decreased as the crystallinity increased; hence, defects were minimized. The Swanepoel method was used to compute the refractive index, and it was found that the refractive index rises as the Cu doping levels rises. The optical band gap energy was observed to decrease from 2.225 eV to 1.941 eV as the Cu content rose from 0% to 8%, and then slightly increase to 1.965 eV at a Cu concentration of 10%. The Burstein–Moss effect may be connected to this observation. The larger grain size, which lessens the dispersion of the grain boundary, was thought to be the cause of the observed increase in the dc electrical conductivity with an increase in Cu doping. In structured undoped and Cu-doped ZnTe films, there were two carrier transport conduction mechanisms that could be seen. According to the Hall Effect measurements, all the grown films exhibited a p-type conduction behavior. In addition, the findings demonstrated that as the Cu doping level rises, the carrier concentration and the Hall mobility similarly rise, reaching an ideal Cu concentration of 8 at.%, which is due to the fact that the grain size decreases grain boundary scattering. Furthermore, we examined the impact of the ZnTe and ZnTe:Cu (at Cu 8 at.%) layers on the efficiency of the CdS/CdTe solar cells.

Effect of bath temperature on the efficiency and properties of Cu 2 O/ZnS/ZnO heterojunctions thin film prepared by electrodeposition and chemical bath deposition methods

CuBi2O4/CuO Heterojunction Coated with Electrodeposited ZnO Overlayer for Stable Solar Hydrogen Evolution

Effect of Reaction Temperature on Surface Morphology and Photoelectric Properties of ZnO Grown by Hydrothermal Method in Mixed Solvent

Effect of solution concentration on surface morphology, optical properties and solar light response of ZnO thin films

Microstructure, Wettability and Electrical Properties of N-Zno/zno-sl/p-cu2o Heterojunction

Electrodeposition of ZnO thin films at low temperature: effects of deposition potential on properties for ZnO/CuO heterojunction solar cells

Effect of Zn-doped CuO thin films on structural, morphological, optical, and electrical properties for photocatalysis application

Effect of Cu doping on the structural, optical and electrical properties of ZnO thin films grown by RF magnetron sputtering: application to solar photocatalysis

Effect of Heat Treatment on the Property of Cuins2 Thin Film Prepared by Chemical Bath Deposition

Investigating the opto-electronic and photovoltaic properties of Zn-incorporated CuO thin film grown by vapor–liquid–solid (VLS) method

Effect of ZnO layer thickness upon optoelectrical properties of NiO/ ZnO heterojunction prepared at room temperature

Influence of water content in mixed solvent on surface morphology, wettability, and photoconductivity of ZnO thin films.

Effects of post-deposition treatment on zinc sulfide thin films prepared by an effective-cost chemical bath deposition method

Microstructural and Optical Characterization of Heterostructures of ZnS/CdS and CdS/ZnS Synthesized by Chemical Bath Deposition Method

Nanocrystalline ZnS thin films by chemical bath deposition method and its characterization

The effects of deposition temperature and ambient on the physical and electrical performance of DC-sputtered n -ZnO/ p -Si heterojunction

Resulting Effect of the p-Type of ZnTe: Cu Thin Films of the Intermediate Layer in Heterojunction Solar Cells: Structural, Optical, and Electrical Characteristics

Effect of Bath Temperature on the Properties of CdS Thin Film Deposited by Chemical Bath Deposition

Effect of Copper Inclusion in Zinc sulfide Thin Films for Photocatalytic Applications

Chemical bath deposition of SnS:Cu/ZnS for solar hydrogen production and solar cells

Effect of Chemical Bath Deposition Variables on the Properties of Zinc Sulfide Thin Films: A Review