Soot formation in laminar flames of ethylene/ammonia

Anthony M. Bennett,Peng Liu,Zepeng Li,Najeh M. Kharbatia,Wesley Boyette,Assaad R. Masri,William L. Roberts
DOI: https://doi.org/10.1016/j.combustflame.2020.06.042
IF: 4.4
2020-10-01
Combustion and Flame
Abstract:<p>Co-firing NH<sub>3</sub> with other fuels is receiving growing interest as a feasible solution to improve its combustion and emission properties. Previous studies mainly focused on NO<em><sub>x</sub></em> emission, and paid less attention to soot formation which is investigated here using a laminar counterflow flame configuration with ethylene fuel (75% by mole) mixed with different proportions of ammonia (between 0 and 25% by mole while the remainder is nitrogen). Soot volume fraction (SVF) was measured using planar laser induced incandescence (PLII). It was found that the addition of ammonia significantly reduced the measured SVF by 4–6% per 1% ammonia addition as compared to the reference flame (25% nitrogen). To rule out temperature effects, the experiments were simulated using Chemkin Pro and it was found that there were negligible differences in temperature between each condition implying that temperature was not responsible for the reduction in SVF. To investigate the chemical effects of ammonia addition, polycyclic aromatic hydrocarbons (PAH) were measured using planar laser induced fluorescence (PLIF) at 4 wavelengths (350 nm, 400 nm, 450 nm, and 500 nm). PLIF intensities at 350 nm is deemed to correlate with PAHs of 2–3 rings and measured profiles at this wavelength were nearly overlapping for all cases. These findings were supported by GC–MS measurements of acetylene and benzene with the latter showing little change in the peak for the cases studied here. At longer wavelengths, PLIF intensities began to show the same trends found for SVF measurements. Additionally, a specific nitrogen detector was used during GC–MS measurements and several nitrogen containing hydrocarbon species were detected with the 25% addition of ammonia. The combined results indicate that the nitrogen containing hydrocarbon species are likely to account for soot reduction, with the precise mechanism yet to be elucidated.</p>
energy & fuels,engineering, chemical, mechanical,thermodynamics, multidisciplinary
What problem does this paper attempt to address?
The main problem that this paper attempts to solve is to explore the influence of co - combustion of ammonia (NH₃) and ethylene (C₂H₄) on soot formation. Specifically, through experimental and simulation methods, the researchers explored how the addition of different proportions of ammonia affects the soot volume fraction (SVF) and the formation of polycyclic aromatic hydrocarbons (PAH) in laminar counter - flow flames. The study found that as the amount of ammonia added increases, the soot volume fraction decreases significantly. For every 1% increase in ammonia, the SVF decreases by about 4 - 6%. In addition, the study also found that the addition of ammonia has little impact on temperature. Therefore, the reduction of soot is mainly attributed to the chemical effect of ammonia, rather than the thermal effect or the collision effect. To further verify this conclusion, the researchers also used planar laser - induced fluorescence (PLIF) and gas chromatography - mass spectrometry (GC - MS) to measure PAH and nitrogen - containing compounds. The results show that the addition of ammonia inhibits the formation of larger PAHs, and in the case of 25% ammonia, a variety of nitrogen - containing compounds were detected. These compounds may be involved in the chemical process of soot formation, but the specific mechanism still needs further study.