The role of enhanced desliming and gravity separation as a precursor to flotation in the upgrading of cassiterite from tailings

M.E. Amosah,M. Yvon,J. Zhou,K.P. Galvin

DOI: https://doi.org/10.1016/j.mineng.2024.108581

IF: 5.479

2024-01-29

Minerals Engineering

Abstract:Due to the depletion of high-grade mineral deposits, there is increasing demand for the reprocessing of minerals from tailings dams. However, tailings reprocessing can present several challenges due to the presence of slimes: reduced selectivity and kinetics resulting in low recovery, excessive entrainment, and high reagent consumption. This research focussed on a previously intractable problem, the processing of a low-grade cassiterite (SnO 2 ) feed from a tailings dam. Conventional technologies have failed to achieve viable recoveries and saleable grades. Therefore, gravity separation and desliming were applied using the REFLUX TM Classifier and the REFLUX TM Graviton, targeting the tin down to ∼ 10 μm, followed by flotation. The REFLUX TM Classifier experiments were performed using an inclined channel spacing of 1.8 mm at ∼ 5 t/m 2 /h and higher. Recoveries of up to 94 % above 20 μm and 50 % below 20 μm were achieved. Importantly, the deslimed product permitted highly effective recovery of the tin by flotation, with final decanted product grades higher than 30 ± 2 wt% tin, and an overall recovery of up to 35 ± 5 %. Desliming with the REFLUX TM Graviton achieved recovery up to 80 %. The scope for further improvement in the grade and recovery is discussed.

engineering, chemical,mining & mineral processing,mineralogy