Abstract:Spray cooling, which has a fast thermal response and low flow rate consumption, is a common and effective thermal management approach for high power electronic systems. Typically, to improve the heat transfer co-efficient (HTC) for spray cooling, the target surface wettability is decreased, promoting nucleation boiling by reducing the surface energy barrier for bubble nucleation. However, the merging of bubbles and the formation of a vapor film have limitations in further increasing the critical heat flux (CHF). Hence, maximizing both the HTC and CHF of spray cooling can be mutually exclusive on the same heated surface. This paper presented a novel design for a vapor-liquid separation structure surface. It consisted of lower micropillars that serve as the vapor separation channel. On top of that, there was an upper multi-layer copper micromesh that wicks and spreads the coolant. Additionally, nano-grass attached to the micromesh to enhance capillary force and increase the nucleation sites simultaneously. Subsequently, we calculated the forward velocity and pressure drop of the droplets passing through the copper mesh to study the effects of droplet velocity and capillary force on heat transfer performance. The results show that the forward velocity of the droplets decreases rapidly as the increase of copper mesh layers and it drops to zero when passing through the third mesh. Therefore, the capillary force generated by the copper mesh is another important factor for the atomized droplets to pass through the copper mesh and reach the target surface. We have proven that all the vapor-liquid separation structure surfaces satisfy the condition Delta Pcap>Delta Ppore+Delta Plocal. Hence, the synergistic effects of the micropillar, copper micromesh, and nano-grass enable a circulation process of wicking-rewetting-vapor evacuation, which improves the onset of nucleate boiling (ONB), enhances the HTC, and increases the maximum heat flux dissipated by the system. Enhanced HTC (7.94 W/cm2/K) and maximum heat flux (817 W/cm2) were achieved at 1.50 ml/s on the vapor-liquid separation structure surfaces (#200 2-layer), representing an enhancement of 79.6% and 80.0% compared with that for the flat surface and the temperature of the heated surface at the ONB maximum decreased by approximately 30.8 degrees C.

Enhancing radical molecular beams by skimmer cooling

Minimising Interference in Low-Pressure Supersonic Beam Sources

Knife edge skimming for improved separation of molecular species by the deflector

Laser Cooling and Trapping of Polar Molecules

Continuous all-optical deceleration and single-photon cooling of molecular beams

Synthesis of Scalable Micro-Droplets with Heat-Driven Effect in Flow-Focusing Device.

Collimated versatile atomic beam source with alkali dispensers

Efficient Isobar Suppression by Photodetachment in a RF Quadrupole Ion Cooler

Cold free radical molecules in the laboratory frame

Purification of Radioactive Ion Beams by Photodetachment in a RF Quadrupole Ion Beam Cooler

Stimulated Laser Cooling in a Compact Geometry Using Microfabricated Atomic Beam Collimators

Laser radiation pressure slowing of a molecular beam

Simulation of longitudinal dynamics of laser-cooled and RF-bunched C$^{3+}$ ion beams at heavy ion storage ring CSRe

Achieving Cooling Without Repump Lasers Through Ion Motional Heating

Theoretical investigation of a two-stage buffer gas cooled beam source

Molecular dynamics investigation of the effect of nanostructured surfaces on flow boiling

Transverse emittance reduction in muon beams by ionization cooling

Experimental and computational investigation on synergistic enhancement spray cooling using micropillars and capillary-driven wicking hybrid structures

High-speed synchrotron X-ray imaging of melt pool dynamics during ultrasonic melt processing of Al6061

Ultrafast Cylindrical Vector Beams for Improved Energy Feedthrough and Low Roughness Surface Ablation of Metals

Enhancing electrospray ionization efficiency for particle transmission through an aerodynamic lens stack