Abstract:There are limited scientific data on contributors to the added drag of in-service ships, represented by modern-day coating roughness and biofouling, either separately or combined. This study aimed to gain an insight into roughness and hydrodynamic performance of typical coatings under in-service conditions of roughened ships' hull surfaces. Comprehensive and systematic experimental data on the boundary layer and drag characteristics of antifouling coating systems with different finishes are presented. The coating types investigated were linear-polishing polymers, foul-release and controlled-depletion polymers. The data were collected through state-of-the-art equipment, including a 2-D laser Doppler velocimetry (LDV) system for hydrodynamic data in a large circulating water tunnel. Three coating systems were first applied on flat test panels with 'normal' finishes in the first test campaign to represent coating applications under idealised laboratory conditions. In order to address more realistic roughness conditions, as typically observed on ships' hulls, 'low' and 'high' roughness densities were introduced into the same types of coating, in the second test campaign. The data collected from the first test campaign served as the baseline to demonstrate the effect on the surface roughness and hydrodynamic drag characteristics of these coating types as a result of 'in-service' or 'severely flawed' coating application scenarios. Data collected on coatings with a range of in-service surface conditions provided a basis to establish correlation between the surface roughness characteristics and hydrodynamic performance (roughness function). The findings of the study indicate that the estimations of drag penalties based on well-applied, relatively smooth coating conditions underestimate the importance of hull roughness, which although undesirable, is commonplace in the world's commercial fleet.

Hydrodynamic frictional performance of fouled panels: a comparative study of different coating types

An experimental investigation into the surface and hydrodynamic characteristics of marine coatings with mimicked hull roughness ranges

Effects of 'in-service' conditions - mimicked hull roughness ranges and biofilms - on the surface and the hydrodynamic characteristics of foul-release type coatings

Wettability Effects of Curved Superhydrophobic Surfaces On Drag Reduction in Taylor-Couette Flows of Water and Oil

On Interfacial Deformation and Resistance Characteristics over Superhydrophobic Surfaces: A Numerical Study

Comparative Experimental Studies on Flow and Noise of Cylinder Affected by Coated and Downstream Metal Foams

Characteristics of Drag Reduction in Different Cross Sections of Hydrophobic Micro Pin Fins

Comparison between super-hydrophobic, liquid infused and rough surfaces: a DNS study

Study on Drag Reduction of Hydrophobic Surface

Frictional drag measurements of large-scale plates in an enhanced plane channel flowcell

Experimental investigation of the anti-soiling performances of different wettability of transparent coatings: Superhydrophilic, hydrophilic, hydrophobic and superhydrophobic coatings

Experimental Evaluation of Compressor Blade Fouling

Evaluation of in-service speed performance improvement by means of FDR-AF (frictional drag reducing anti-fouling) marine coating based on ISO19030 standard

Airside Heat Transfer and Friction Characteristics for Enhanced Fin-and-tube Heat Exchanger with Hydrophilic Coating under Wet Conditions

Investigation of the drag reduction performance of bionic flexible coating

Prediction of resistance induced by surface complexity in lubricating layers: Application to super-hydrophobic surfaces

Analysis of Fouling on Nanocomposite Surfaces in Plate Heat Exchangers

Effects of Simulated Surface Roughness on Flow Characteristics in Symmetrical Airfoil

Effects of Hydrophilic Coating on Air Side Heat Transfer and Friction Characteristics of Wavy Fin and Tube Heat Exchangers under Dehumidifying Conditions

Effects of surface roughness on the drag coefficient of finite-span cylinders freely rolling on an inclined plane

Influence of Surface Slip on Hydrodynamics and Flow Field Around a Two-Dimensional Hydrofoil at a Moderate Reynolds Number