Abstract:This work presents a hydrothermal-based facile method for synthesizing ZnFe 2 O 4, whose size can be controlled with the concentration of sodium acetate used as a fuel and its physical changes at nanoscales when exposed to two different gases. The structural, morphological, compositional, and electronic properties of the synthesized samples are also presented in this paper. The crystal structure of the synthesized samples was determined using an X-ray Diffractometer (XRD). The results revealed fluctuations in the size, lattice parameter, and strain in the nanoparticles with increasing the concentration of sodium acetate. Field-Emission Scanning Electron Microscopy (FESEM) was used to determine synthesized materials' morphology and particle size. It revealed that the particles possessed approximately spherical morphology whose size decreased significantly with the increasing amount of sodium acetate. Transmission Electron Microscopy (TEM) was utilized to determine the structure, morphology, and elemental distributions in particles at the nanoscale, and it confirmed the findings of XRD and FESEM analyses. The high-resolution TEM (HRTEM) imaging analysis of the nanoparticles in our studied samples revealed that the particles predominantly possessed (001) type facets. X-ray photoelectron spectroscopy (XPS) and core-loss electron energy loss spectroscopy (EELS) showed an increasing fraction of Fe 2+ with the decreasing size of the particles in samples. The Brunauer, Emmett, and Tellers (BET) analysis of samples revealed a higher surface area as the particle size decreases. In addition, the determined surface area and pore size values are compared with the literature, and it was found that the synthesized materials are promising for gas-sensing applications. The ab initio calculations of the Density of States (DOS) and Band structure of (001) surface terminating ZnFe 2 O 4 were carried out using Quantum Espresso software to determine the bandgap of the synthesized samples. They were compared to their corresponding experimentally determined bandgap values and showed close agreement. Finally, in-situ TEM measurement was carried out on one of the four studied samples with robust properties using Ar and CO 2 as reference and target gases, respectively. It is concluded from the presented study that the size reduction of the ZnFe 2 O 4 nanoparticles (NPs) tunes the bandgap and provides more active sites due to a higher concentration of oxygen vacancies. The in-situ TEM showed us a nanoscale observation of the change in one of the crystal structure parameters. The d spacing of ZnFe 2 O 4 NPs showed a noticeable fluctuation, reaching more than 5% upon exposure to CO 2 and Ar gases.

Synthesis and characterization of Fe-doped ZnO films for enhanced NO2 gas-sensing applications

A highly sensitive and selective ZnO-based ammonia sensor: Fe- doping effect

Enhanced NO2 gas sensing performance of Ni-doped ZnO nanostructures

Synthesis, Characterization and Gas Sensing Study of ZnO-SnO2 Nanocomposite Thin Films

Synthesis and Characterization of Nanostructured Cerium-Doped Zinc Oxide Thin Films for Selective Nitrogen Dioxide Gas Sensing Applications

Selective Oxygen Sensor Prepared Using Ni-doped Zinc Ferrite Nanoparticles

Quick NO Gas Sensing by Ti-Doped Flower-Rod-like ZnO Structures Synthesized by the SILAR Method

Synthesis, characterization, and preliminary insights of ZnFe2O4 nanoparticles into potential applications, with a focus on gas sensing

Hydrothermal synthesis of NO2 gas-sensitive and hydrophobic zinc oxide thin films

Zn mixed CeO2 nanoparticles: Enhancement of NO2 gas sensing performance

Role of oxygen vacancies on Li-doped Ni:ZnO thin films for enhanced NO2 gas sensing applications

ZIF-derived Nanoparticles Modified ZnO Nanorods Hierarchical Structure for Conductometric NO2 Gas Sensor

Enhanced NO2 Gas Sensing Properties Based on Rb-Doped ZnO/In2O3 Heterojunctions at Room Temperature: A Combined DFT and Experimental Study

Superior NO 2 Sensing of MOF-Derived Indium-Doped ZnO Porous Hollow Cages

Synthesis and Characterization of Flower-Like Cobalt-Doped ZnO Nanostructures for Ammonia Sensing Applications

Ultrasensitive Ppb-Level NO2 Gas Sensor Based on WO3 Hollow Nanosphers Doped with Fe

SILAR-engineered ZnO thin films: exploring the impact of Ni, Co, and Fe dopants on structural, optical, and electronic properties

The Influence of Different ZnO Nanostructures on NO2 Sensing Performance

Aerosol assisted chemical vapour deposition of nanostructured ZnO thin films for NO2 and ethanol monitoring

Chemical spray pyrolysis deposited ZnO/ZIF-8 and cobalt doped ZnO/ZIF-8 composite thin films for highly sensitive and selective ammonia sensing at room temperature

High Gas Sensitivity to Nitrogen Dioxide of Nanocomposite ZnO-SnO2 Films Activated by a Surface Electric Field