Resilient And Tough Conductive Polymer Hydrogel for Low Hysteresis Strain Sensor

Chunyan Cao,Tao Huang,Yunming Li
DOI: https://doi.org/10.1002/marc.202300467
IF: 5.006
2023-10-22
Macromolecular Rapid Communications
Abstract:Conductive polymer hydrogels are widely used in strain sensors, but achieving both high resilience and high toughness remains challenging. To address this issue, this paper presents a pre‐stretch approach to engineer a tough conductive polymer hydrogel with sufficient resilience. Initially, a blend film of polyvinyl alcohol (PVA) and ethylene‐vinyl alcohol copolymer (EVOH) was prepared through solution casting, followed by a swelling process to form a PVA‐EVOH hydrogel. The PVA‐EVOH hydrogel contains PVA crystallites as multifunctional crosslinking points, resulting in high toughness. Subsequently, the PVA‐EVOH hydrogel was sequentially immersed in pyrrole and ferric chloride solutions for in‐situ polymerization of polypyrrole (PPy), yielding a conductive PPy/PVA‐EVOH hydrogel. Finally, a 200% pre‐stretching was applied to the PPy/PVA‐EVOH hydrogel, breaking short chains within the polymer network and thus eliminating energy dissipation at low strains. This endows the hydrogel with a high elastic deformation range of 100% strain, while maintaining high fracture toughness (1700 J/m2). The pre‐stretched PPy/PVA‐EVOH hydrogel can serve as a strain sensor with low hysteresis, providing consistent strain measurement during both loading and unloading periods. This performance is superior to that of the non‐prestretched sample, which exhibits inconsistent responses between the stretching and releasing processes. This article is protected by copyright. All rights reserved
polymer science
What problem does this paper attempt to address?