Lang Zeng,Xichuan Ma,Hao-Hsuan Chen,Yan Zhou,Deming Zhang,Yijiao Wang,Youguang Zhang,Weisheng Zhao
Abstract:The noise of a spin torque oscillator (STO) is 4–6 orders higher than that of a traditional CMOS Voltage Controlled Oscillator (VCO). This is the biggest obstacle hindering the STO to replace the VCO in pragmatic usage since a high quality RF signal is essential to the modern telecommunication system. The phase-locked loop (PLL) is widely used in RF chips, which can both stabilize VCO frequency and reduce its noise. There are very few experimental and theoretical works investigating the STO stabilized by the PLL, whereas the numerical investigation is totally missing. In this work, the STO stabilized by the PLL is numerically investigated. Based on the analysis, a combinational frequency tuning method is proposed, which is suitable for the PLL operation and can reduce the STO noise even further.
What problem does this paper attempt to address?
The problem that this paper attempts to solve is: how to reduce the noise of Spin Torque Oscillator (STO) so that it can replace the traditional CMOS Voltage - Controlled Oscillator (VCO) in modern telecommunication systems.
Specifically, the noise of STO is 4 to 6 orders of magnitude higher than that of the traditional VCO, which is the main obstacle preventing STO from replacing VCO in practical applications. To overcome this problem, the author proposes to use a Phase - Locked Loop (PLL) combined with a combined frequency tuning method to further reduce the noise of STO.
### Main problems:
1. **Excessively high STO noise**: The noise level of STO is much higher than that of the traditional VCO, which makes it difficult to be used in modern telecommunication systems that require high - quality radio - frequency (RF) signals.
2. **Insufficient application of PLL**: Although PLL can be used to stabilize the frequency of VCO and reduce its noise, research on the combination of STO and PLL is very limited, especially the lack of numerical simulation research.
3. **Limitations of existing technologies**: Existing experimental and theoretical work shows that even with PLL, the noise of STO is still much higher than that of VCO, so new technologies are required to further reduce the noise.
### Solutions:
- **Numerical simulation research**: Conduct numerical simulation research on the combination of STO and PLL to explore its noise characteristics.
- **Combined frequency tuning method**: Propose a combined frequency tuning method, combining current modulation and magnetic field modulation, to further reduce the phase noise of STO.
### Key formulas:
- STO oscillation frequency formula:
\[
f(\theta)=\frac{c}{2\pi}(H_{\text{appl}}+(H_k - 4\pi M_s)\cos(\theta))
\]
where \(\theta\) is the oscillation angle starting from the z - axis, \(H_{\text{appl}}\) is the applied magnetic field, \(H_k\) is the anisotropic field, and \(M_s\) is the saturation magnetization.
- Injection current formula:
\[
I(\theta)=\frac{2a_ekM_sSd}{\mu_0}\sqrt{\frac{1 - k^2\sin^2(\theta)}{H_{\text{appl}}+(H_k - 4\pi M_s)\cos(\theta)}}\sin^2(\theta)
\]
Through these methods, the author hopes to provide theoretical basis and technical support for future STO noise reduction technologies and PLL circuit design.