Characteristics and EOR mechanisms of nanofluids permeation flooding for tight oil

DING Bin,Chunming XIONG,GENG Xiangfei,GUAN Baoshan,PAN Jingjun,XU Jianguo,DONG Jingfeng,Chengming ZHANG,Bin DING,Xiangfei GENG,Baoshan GUAN,Jingjun PAN,Jianguo XU,Jingfeng DONG

DOI: https://doi.org/10.1016/s1876-3804(20)60096-9

IF: 5.194

2020-08-01

Petroleum Exploration and Development

Abstract:<p>Tight oil reservoir development is faced with the key technical problem that "water cannot be injected and oil cannot be produced" yet. With the diphenyl ethers water-soluble (gemini) surfactants as water phase shell and C₁₀–C₁₄ straight-chain hydrocarbon compounds as oil phase kernel, a nanofluids permeation flooding system was prepared by microemulsion technology, and its characteristics and EOR mechanisms were evaluated through experiments. The system has the following five characteristics: (1) "Small-size liquid": the average particle size of the system is less than 30 nm, which can greatly reduce the starting pressure gradient of water injection, and effectively enter and expand the sweep volume of micro-nano matrix; (2) "Small-size oil" : the system can break the crude oil into "small-size oil" under the flow condition, which can greatly improve the percolation ability and displacement efficiency of the crude oil in the micro-nano matrix; (3) Dual-phase wetting: the system has contact angles with the water-wet and oil-wet interfaces of (46±1)° and (68±1)° respectively, and makes it possible for capillarity to work fully under complex wetting conditions of the reservoir; (4) High surface activity: the interfacial tension between the system and crude oil from a tight oil reservoir in Xinjiang is 10⁻³–10⁻² mN/m, indicating the system can effectively improve the displacement efficiency of oil in fine pore throats; (5) Demulsification and viscosity reduction: the system has a demulsification and viscosity reduction rate of more than 80% to inversely emulsified crude oil from a tight oil reservoir in Xinjiang, so it can improve the mobility of crude oil in the reservoir and wellbore. The system can be used to increase oil production by fracturing in tight reservoirs, replenish formation energy by reducing injection pressure and increasing injection rate, and enhance oil recovery by displacement and cyclic injection, providing key technical support for effective production and efficient development and recovery enhancement of tight reservoirs.</p>

energy & fuels,geosciences, multidisciplinary,engineering, petroleum

What problem does this paper attempt to address?

The paper attempts to address the key technical challenges encountered in the development of tight oil reservoirs—"difficulty in water injection and oil extraction." Specifically, tight oil reservoirs are characterized by low permeability, low porosity, micro-nano pore throats, and low fluid saturation, which make conventional water flooding and chemical injection methods ineffective in significantly improving oil mobility and recovery rates. To tackle these challenges, the research team developed a system based on nanofluid seepage oil displacement technology, aiming to enhance fluid mobility and improve oil displacement efficiency.

The main issues mentioned in the paper include:
1. **Poor fluid mobility**: The high viscosity and extremely low mobility of crude oil in tight oil reservoirs make conventional water flooding techniques ineffective in improving recovery rates.
2. **Injection difficulty**: Due to the small pore throat sizes, conventional chemical agents and water flooding fluids struggle to enter the micro-nano pores of the reservoir, resulting in poor injection performance.
3. **Complex wettability**: The complex wettability of tight oil reservoirs, with both hydrophilic and oleophilic interfaces, makes conventional water flooding techniques ineffective in certain areas.
4. **Emulsification and viscosity increase**: Some surfactants may cause emulsification or reverse emulsification reactions with crude oil, leading to larger oil particles or increased apparent viscosity, further hindering oil mobility.

To address these issues, the research team developed a novel nanofluid seepage oil displacement system with the following features:
- **Small droplet size**: With an average particle size of less than 30 nanometers, it can significantly reduce the water injection starting pressure gradient, effectively entering and expanding the oil-swept volume in the micro-nano matrix.
- **Small oil droplet size**: Under flow conditions, it can break down crude oil into "small oil droplets," significantly enhancing the permeability and displacement efficiency of crude oil in the micro-nano matrix.
- **Biphasic wettability**: The system has contact angles of (46±1)° and (68±1)° on hydrophilic and oleophilic interfaces, respectively, allowing it to fully utilize capillary forces under complex wettability conditions.
- **High surface activity**: The interfacial tension between the system and crude oil from the Xinjiang tight oil reservoir is 10^-3–10^-2 mN/m, effectively improving the displacement efficiency of crude oil in fine pore throats.
- **Demulsification and viscosity reduction**: The system achieves a demulsification and viscosity reduction rate of over 80% for reverse emulsified crude oil from the Xinjiang tight oil reservoir, enhancing the mobility of crude oil in the reservoir and wellbore.

Experimental evaluations show that this system performs excellently in improving fluid mobility and enhancing oil displacement efficiency, providing critical technical support for the effective development of tight oil reservoirs.