Li−Ca bimetallic hydrogel for efficient water harvesting in arid areas

Zhengyu Luo,Qianqian Huang,Nanbing Jiang,Minfei Xie,Peng Xiao,Lin Yang,Yunhuai Zhang
DOI: https://doi.org/10.1016/j.jwpe.2024.105981
IF: 7
2024-09-04
Journal of Water Process Engineering
Abstract:The use of advanced adsorbents to collect atmospheric water for freshwater production has become a promising approach to alleviate water scarcity. However, the water harvesting capacity of most adsorbents is limited when the relative humidity (RH) is below 30 %. In this study, a porous bimetallic hygroscopic polymer hydrogel (Bime-HPH) film was prepared by freeze-drying method using sodium carboxymethyl cellulose (CMC), a low-cost renewable biomass, as a polymer matrix in combination with hygroscopic salts (CaCl 2 and LiCl). It was found that the strong hydration energy of Li + helps to trap water molecules in arid air and transport them to Ca 2+ and hydrophilic groups on the CMC, and this synergistic effect contributed to the high capacity of Bime-HPH of 1.64 g g −1 at 30 % RH. Moreover, the porous structure facilitated water release from the hydrogel at nearly 40 °C and demonstrated rapid an adsorption-desorption kinetics. In a natural conditions, 16.0 g of Bime-HPH collected a total of 20.0 g of atmospheric water during the night and achieved a water production rate of 1.0 g g −1 h −1 under sunlight irradiation. The special features of the hydrogel will lead to a high demand for its use in many arid regions and communities facing the crisis of water shortage.
engineering, chemical, environmental,water resources
What problem does this paper attempt to address?